TCN75AVUA713 datasheet(9/32 Pages) MICROCHIP

9 / 32 page

DS21935C-page 9

TCN75A

FIGURE 4-1:

Device Addressing.

4.1.5

DATA VALID

After the Start condition, each bit of data in

transmission needs to be settled for a time specified by

tSU-DATA before SCL toggles from low-to-high (see

“Sensor And EEPROM Serial Interface Timing

Specifications” on Page 4).

4.1.6

ACKNOWLEDGE (ACK)

Each receiving device, when addressed, is obliged to

generate an ACK bit after the reception of each byte.

The master device must generate an extra clock pulse

for ACK to be recognized.

The acknowledging device pulls down the SDA line for

tSU-DATA before the low-to-high transition of SCL from

the master. SDA also needs to remain pulled down for

tH-DATA after a high-to-low transition of SCL.

During read, the master must signal an End-of-Data

(EOD) to the slave by not generating an ACK bit (NAK)

once the last bit has been clocked out of the slave. In

this case, the slave will leave the data line released to

enable the master to generate the Stop condition.

1 234

678

SCL

SDA

0 1 A2 A1 A0

Start

Address Byte

Slave

Address

R/W

TCN75A Response

Code

Address

TCN75AVUA713 数据表(PDF) 9 Page - Microchip Technology

TCN75AVUA713 数据表(HTML) 9 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

数据表下载