MCP9805T-BESLASHST datasheet(21/34 Pages) MICROCHIP

21 / 34 page

DS21977B-page 21

MCP9805

FIGURE 5-1:

Device Addressing.

5.1.5

DATA VALID

After the Start condition, each bit of data in transmis-

sion needs to be settled for a time specified by tSU-DATA

before SCLK toggles from low-to-high (see Serial

Interface Timing Characteristics).

5.1.6

ACKNOWLEDGE (ACK)

Each receiving device, when addressed, is obliged to

generate an ACK bit after the reception of each byte.

The master device must generate an extra clock pulse

for ACK to be recognized.

The acknowledging device pulls down the SDA line for

tSU-DATA before the low-to-high transition of SCLK from

the master. SDA also needs to remain pulled down for

tH-DATA after a high-to-low transition of SCLK.

During read, the master must signal an End-of-Data

(EOD) to the slave by not generating an ACK bit (NAK)

once the last bit has been clocked out of the slave. In

this case, the slave will leave the data line released to

enable the master to generate the Stop condition.

5.1.7

TIME OUT

If the SCLK stays high or low for a time specified by

tOUT, the MCP9805 releases the bus and resets the

serial interface. The master will have to restart the

communication cycle with a Start condition. This

dictates the minimum clock speed.

2345

SCLK

SDA

1 A2 A1 A0

Start

Address Byte

Slave

Address

R/W

MCP9805 Response

Code

Address

MCP9805T-BE/ST 数据表(PDF) 21 Page - Microchip Technology

MCP9805T-BE/ST 数据表(HTML) 21 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

数据表下载