OP97

Rev. G | Page 5 of 16

ABSOLUTE MAXIMUM RATINGS

Absolute maximum ratings apply to both DICE and packaged

parts, unless otherwise noted.

Table 3.

Parameter

Rating

Supply Voltage

±20 V

Input Voltage1

±20 V

Differential Input Voltage2

±1 V

Differential Input Current2

±10 mA

Output Short-Circuit Duration

Indefinite

Operating Temperature Range

OP97E, OP97F (P, S)

−40°C to +85°C

Storage Temperature Range

−65°C to +150°C

Junction Temperature Range

−65°C to +150°C

Lead Temperature (Soldering, 60 sec)

300°C

1 For supply voltages less than ±20 V, the absolute maximum input voltage is

equal to the supply voltage.

2 The inputs of the OP97 are protected by back-to-back diodes. Current-

limiting resistors are not used in order to achieve low noise. Differential

input voltages greater than 1 V cause excessive current to flow through the

input protection diodes unless limiting resistance is used.

Stresses above those listed under Absolute Maximum Ratings

may cause permanent damage to the device. This is a stress

rating only; functional operation of the device at these or any

other conditions above those indicated in the operational

section of this specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may affect

device reliability.

THERMAL RESISTANCE

θJA is specified for the worst-case conditions, that is, a device

soldered in a circuit board for surface-mount packages.

Table 4.

Package Type

θJA1

θJC

Unit

8-Lead PDIP (P Suffix)

103

43

°C/W

8-Lead SOIC (S Suffix)

158

43

°C/W

1 θJA is specified for worst-case mounting conditions, that is, θJA is specified for

device in socket for PDIP package; θJA is specified for device soldered to

printed circuit board for SOIC package.

ESD CAUTION