TIG030TS

No. A0637-4/4

PS

SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using

products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition

ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.

products described or contained herein.

SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all

semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or

malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise

to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt

safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not

limited to protective circuits and error prevention circuits for safe design, redundant design, and structural

design.

Upon using the technical information or products described herein, neither warranty nor license shall be granted

with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third

party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's

intellctual property rights which has resulted from the use of the technical information and products mentioned

above.

Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed

for volume production.

Any and all information described or contained herein are subject to change without notice due to

product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the

SANYO Semiconductor Co.,Ltd. product that you intend to use.

In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are

controlled under any of applicable local export control laws and regulations, such products may require the

export license from the authorities concerned in accordance with the above law.

No part of this publication may be reproduced or transmitted in any form or by any means, electronic or

mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,

without the prior written consent of SANYO Semiconductor Co.,Ltd.

Note : TIG030TS has protection diode between gate and emitter but handling it requires sufficient care to

be taken.

IT11965

20

40

60

80

100

120

140

0

160

50

0

100

150

200

250

300

350

400

450

Collector Current (Pulse), ICP -- A

CM -- ICP

ICP -- VGE

Gate-to-Emitter Voltage, VGE -- V

VCM=330V

Tc

≤70°C

VGE=4V

RG≥50Ω

IT09937

24

5

6

7

8

3

1

0

0

20

40

60

80

100

120

140

160

CM=400µF

Tc=25

°C

Tc=70

°C

Turn OFF dv / dt -- RG

Gate Series Resistance, RG -- Ω

Collector Current, IC -- A

SW Time -- IC

IT11964

40

80

100

120

60

20

0

0

100

200

300

400

500

600

23

5

7

3

2

100

10

IT11963

1000

5

3

2

7

7

5

3

2

5

100

td(off)

t r

td(on)

RL=2.2Ω, Tc=25°C

VGE=4V, RG=82Ω

PW=

50

µs

tf

Xe -Tube Load

VCC=330V, ICP=120A,

VGE=4V, PW=50µs

Driver :

SANYO TND721MH5

Tc=25

°C

This catalog provides information as of May, 2007. Specifications and information herein are subject

to change without notice.