SAM9X75 SiP

Data Sheet

© 2023 Microchip Technology Inc. and its subsidiaries

DS60001827B - 2

– Power-on reset cells, reset controller, shutdown controller, periodic interval timer, watchdog timer

running on internal slow RC oscillator (32 kHz typical) and real-time clock running on slow crystal

oscillator (32.768 kHz)

– Two internal trimmed RC oscillators with typical values: 32 kHz (slow) and 12 MHz (fast)

– Two crystal oscillators: 32.768 kHz (slow) and 20 to 50 MHz (fast)

– One PLL for the system and one PLL optimized for USB high-speed operation (480 MHz)

• One PLL for audio operations, with dedicated output clock

• One PLL in LVDS I/F (LVDS usage only)

• One PLL in MIPI DPHY (MIPI DSI usage only)

– One dual-port 16-channel DMA controller

– Advanced interrupt controller and debug unit

– JTAG port with disable bit in OTP memory

– Two programmable clock output signals

• Low-Power Modes

– Backup mode with RTC, eight 32-bit general purpose backup registers, and shutdown controller to

control the external power supply

– Clock generator and power management controller

– Software-programmable ultra-low power modes: very slow clock operating mode (ULP0) and no-clock

operating mode (ULP1) with fast wake-up capabilities

– Software programmable power optimization capabilities

• Peripherals

– LCD controller with overlay, alpha blending, rotation, scaling and color conversion; up to 720p resolution

• RGB, LVDS, MIPI-DSI interfaces

– 2D graphics controller supporting fill BLT, copy BLT, transparent BLT, blend/alpha BLT, ROP4 BLT (raster

operations) and command ring buffer

– Image sensor controller with ITU-R BT; 601/656/1120 video interface support up to 5 Mpixels; support of

raw Bayer 12, YCbCr, monochrome and JPEG compressed sensors up to 12 bits

• MIPI CSI2 I/F support

• 12-bit parallel I/F support

– One high-speed USB device, three high-speed USB hosts with dedicated on-chip transceivers

– One 10/100/1000 Mbps Ethernet Mac controller with IEEE-1588 and TSN support, RGMII and RMII

support

– Two 4-bit secure digital multimedia card controllers

– Two CAN FD controllers with timestamping

– One Quad/Octal SPI controller

– Two 3-channel 32-bit timers/counters

– Two high-resolution (64-bit) periodic interval timers

– One synchronous serial controller

– One inter-IC sound multi-channel controller with TDM support

– One audio class D controller with single-ended or bridge-tied load connection to power stage

– One 4-channel 16-bit PWM controller

– Thirteen FLEXCOMs (USART, SPI and TWI/I2C)

– One 8-channel, 12-bit, analog-to-digital converter with 4/5 wires resistive touchscreen support