SNAP MOUNT TYPE ALUMINUM ELECTROLYTIC CAPACITORS

Environmental code

Plate code

Sealing code

Case height code

Case dia code

Terminal code

Capacitance tolerance code

Capacitance code

Rated voltage code

(Example) PS2 Series 500V 1,000

μF ±20%

PS2 2H 102 M T C

PH

S11

WP PF

Type of

series

PS2 Series

• Conform RoHS

Features

• Higher ripple though use of low-ESR material consequently, the permissible ripple

current is improved by 27% in the windless status or 40% in the ventilated condition

(0.5m/s) as compared with conventional constructions (HP3 series).

• Improvement in air exhaust (flow hole phenomenon) from the terminal insertion hole at

solder fixing though improvement of cap condtruction.

• The operating spase of the safety vent (arranged on the case bottom) is reduced from

5mm (conventional necessary distance) into 1mm through improvement of case

construction. For these new case construction, pattern desigh can be move flexible.

Product Specifications

Product code

Terminal permissible current is limited to 15Arms (

φ41, 46),

20Arms (

φ51).

(Even if calculated the permissible ripple current with the

correction coefficient exceeds 15, 20 Arms)

Please consult us when the ripple voltage exceeds 70Vp-p.

NEW!

Ripple current correction coefficient

Temperature (

℃)

406085

Correction

coefficient

200

∼500V.DC

1.89

1.51

1.00

550

∼600V.DC

1.65

1.45

1.00

Frequency (Hz)

50/60

120

300

1K

≧10K

Correction coefficient

0.7

1.0

1.1

1.3

1.4

Forced wind (m/s)

＜0.5

0.5

≦

Correction coefficient

1.0

1.1

HP3

→

PS2

P.84 High-ripple current

Items

Specifications

Temperature range

−40℃∼ ＋85℃（200 ∼ 500V.DC）

−25℃∼ ＋85℃（550, 600V.DC）

Rated voltage

200

∼ 600V.DC

Capacitance tolerance

±20%（20℃，120Hz）

Leakage current

0.01CV (

μA) or 5mA, whichever is smaller or less（20℃，after 5 minutes）

［C = nominal capacitance (μF), V ＝ rated voltage (V)］

Dissipation factor

Less than the value specified in the standard products table.

（20℃，120Hz）

Permissible ripple current

As specified in the standard product table.

（85℃，120Hz）

Endurance

After the rated voltage with specified ripple current is applied at 85

℃ for 2,000 hours :

Capacitance change : Within

±15% of the initial value measured

Dissipation factor

: 175% or less than the initial value specified

Leakage current

: Less than or equal to the initial value specified

Shelf life

The following specification shall be meet when the capacitor are restored to 20

℃ after storage of 500 hours

at 85

℃ with no voltage applied. Before the measurement, the capacitor shall be preconditioned by applying

the voltage treatment according to Item 4.1 of JIS C 5101-4.

Capacitance change : Within

±15% of the initial value measured

Dissipation factor

: 175% or less than the initial value specified

Leakage current

: Less than or equal to the initial value specified

Others

J

ⅠS C 5101-4