TS5201 series

3-6

2005/08 rev. C

Electrical Characteristics (continued)

Note 1: Exceeding the absolute maximum rating may damage the device.

Note 2: The maximum allowable power dissipation at any Ta is Pd(max) = [ Tj(max) - Ta] + Өja. Exceeding the

maximum allowable power dissipation will result in excessive die temperature, and the regulator will go into

thermal shutdown.

Note 3: The device is not guaranteed to function outside its operating rating.

Note 4: Output voltage temperature coefficient is defined as the worst case voltage change divided by the total

temperature range.

Note 5: Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts are tested

for load regulation in the load range from 1mA to 200mA. Changes in output voltage due to heating effects

are covered by the thermal regulation specification.

Note 6: Dropout voltage is defined as the input to output differential at which the output voltage drops 2% below its

nominal value measured at 1V differential.

Note 7: Ground pin current is the regulator quiescent current plus pass transistor base current. The total current

drawn from the supply is the sum of the load current plus the ground pin current.

Note 8: Thermal regulation is defined as the change in output voltage at a time “t” after a change in power dissipation

is applied, excluding load or line regulation effects. Specifications are for a 200mA load pulse at Vin=16V for

t=10mS.

Block Diagrams

Vout = Vref x (1+R2/R1)