E5C4

E5C4

6

Precautions

Mounting

Track Mounting (E5C4 with P2CF-08)

When mounting two or more E5C4 models with track-mounting

sockets, leave a space of approximately 20 mm on both sides of the

sockets where hooks are located.

Panel

Hook

Duct

P2CF-08

Flush Mounting

Insert E5C4 into the square hole of the panel and insert an adapter

from the back so that there will be no space between E5C4 and the

panel. Then, secure the E5C4 with a screw.

Tightening screw

The P3G-08 can be wired in the same way as the P2CF-08.

Dismounting

If flush mounted, loosen the screw of the adapter and disengage the

hooks for dismounting.

Temperature Setting

The leftmost digit of any E5C4 that has a set temperature range

from 0

°C to 399°C will increase by 1 within a range of 0 to 3 each

time the push button for the leftmost digit is pressed. The leftmost

digit indicating 3 will change to 0 when the push button is pressed.

Others

Do not remove the housing of the E5C4, otherwise the housing may

break.

To clean the surface of the E5C4, use a soft cloth wet with neutral

detergent or alcohol. Do not use any organic solvent, such as paint

thinner or benzine, strong acid or strong alkali to clean the surface of

the E5C4, otherwise the surface of the E5C4 will become damaged.