ISD5216P datasheet(21/75 Pages) WINBOND

21 / 75 page

ISD5216

Publication Release Date: Jan. 31, 2006

- 21 -

Revision B.4

transmitting data that is synchronized with the leading edge (see the timing specifications at the back

of this data sheet).

Note that the specifications are defined by the transmitter speed. The specification of the receiver has to be able to match the

performance of the transmitter.

7.4.2. Word Select

The word select line indicates the channel being transmitted:

• WS = 0; channel 1 (left)

• WS = 1; channel 2 (right)

WS may change either on a trailing or leading edge of the serial clock, but it doesn’t need to be

symmetrical. In the slave, this signal is latched on the leading edge of the clock signal. The WS line

changes one clock period before the MSB is transmitted. This allows the slave transmitter to derive

synchronous timing of the serial data that will be set up for transmission. Furthermore, it enables the

receiver to store the previous word and clear the input for the next word (see figure Timing for I

Transmitter

on previous page.)

7.4.3. Timing

In the I

2S format, any device can act as the system master by providing the necessary clock signals. A

slave will usually derive its internal clock signal from an external clock input. This means, taking into

account the propagation delays between master clock and the data and/or word-select signals, the

total delay is simply the sum of:

• the delay between the external (master) clock and the slave’s internal clock; and

• the delay between the internal clock and the data and/or word-select signals.

For data and word-select inputs, the external to internal clock delay is of no consequence because it

only lengthens the effective set-up time (see figure Timing for I

2S Transmitter on previous page.) The

major part of the time margin is to accommodate the difference between the propagation delay of the

transmitter, and the time required to set up the receiver.

All timing requirements are specified relative to the clock period or to the minimum allowed clock

period of a device. This means that higher data rates can be used in the future.

Timing for I

2S Receiver

Note that the specifications are defined by the transmitter speed. The specification of the receiver has to be able to match the

performance of the transmitter.

SCK

and

tLC > 0.35T

tar > 0.2T

tHC > 0.35

tar > 0

VH = 2.0V

VL = 0.8V

T = clock period

TR = minimum allowed clock period for transmitter

T > TR

ISD5216P 数据表(PDF) 21 Page - Winbond

ISD5216P 数据表(HTML) 21 Page - Winbond

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

数据表下载