This Data Sheet may be revised by subsequent versions

©2004 Eon Silicon Solution, Inc., www.essi.com.tw

or modifications due to changes in technical specifications.

21

EN25B16

Rev. C, Issue Date: 2006/12/22

Read Manufacturer / Device ID (90h)

The Read Manufacturer/Device ID instruction is an alternative to the Release from Power-down / Device

ID instruction that provides both the JEDEC assigned manufacturer ID and the specific device ID.

The Read Manufacturer/Device ID instruction is very similar to the Release from Power-down / Device ID

instruction. The instruction is initiated by driving the CS# pin low and shifting the instruction code “90h”

followed by a 24-bit address (A23-A0) of 000000h. After which, the Manufacturer ID for Eon (1Ch) and the

Device ID are shifted out on the falling edge of CLK with most significant bit (MSB) first as shown in Figure

17. The Device ID values for the EN25B16 are listed in Table 5. If the 24-bit address is initially set to

000001h the Device ID will be read first