AMMLP series

Low Power, Low Jitter MEMS Oscillator

Revision:

Initial Release 4/30/2024

Page 2

Disclaimer

Check Inventory

S

Request Samples

Parameters

Min.

Typ.

Max.

Units

Notes

Input Logic Levels

VIH

0.7*VDD

V

Input logic High, Note 3

VIL

0.3*VDD

Input logic Low, Note 3

Power Supply Ramp (tPU)

0.1

100

ms

Note 2

Start-up Time (tsu)

2.5

ms

From 90% VDD until the output start toggling

Output Enable Time (tOE)

1

µs

Pin 1 configured as OE

2

ms

Pin 1 configured as Standby

Output Disable Time (tODS)

15

ns

From OE toggle to output OFF

Rise (Tr) / Fall (Tf) Time

20% ↔ 80%, CL= 10 pF

1.4/1.3

ns

VDD = 1.8V

1.1/1.0

VDD = 2.5V

1.2/1.0

VDD = 3.3V

Cycle-to-Cycle Jitter (Peak)

FOUT = 25MHz

40

ps

VDD = 1.8V

18

VDD = 2.5V

15

VDD = 3.3V

Period Jitter (Peak-to-Peak)

FOUT = 25MHz

45

ps

VDD = 1.8V

20

VDD = 2.5V

18

VDD = 3.3V

RMS Period Jitter

FOUT = 25MHz

6

ps

VDD = 1.8V

2.5

VDD = 2.5V

2.5

VDD = 3.3V

RMS Phase Jitter

1

ps

VDD = 3.3V, Ta = 25°C± 3°C,

12kHz to 20MHz, FOUT = 100MHz

Parameters

Min.

Typ.

Max.

Units

Notes

Supply Voltage

-0.3

+4.0

V

LVTTL Input Voltage

-0.3

VDD+0.3

V

Maximum Junction Operating Temperature

+125

ºC

Ambient Operating Temperature Range

-40

+125

ºC

Extended Industrial

Ambient Operating Temperature Range

-40

+105

ºC

Extended Industrial

Ambient Operating Temperature Range

-40

+85

ºC

Industrial

Ambient Operating Temperature Range

-20

+70

ºC

Extended Commercial

Reflow Temperature

+260

ºC

See Reflow Profile

ESD Protection

4kV HBM, 400V MM, 2kV CDM

Absolute Maximum Ratings (Note 4)

Note 1:

Overall frequency stability includes initial frequency tolerance @25°C± 3°C and stability over the operating temperature range.

Note 2:

Time to reach 90% of target VDD. Power ramp must be monotonic.

Note 3:

Input waveform must be monotonic with rise/fall time <10 ms.

Note 4:

Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.

This is a stress rating only and functional operation of the device at those or any other conditions above those indicated

in the operational sections of this specification is not intended. Exposure to maximum rating conditions for extended

periods may affect device reliability. The data sheet limits are not guaranteed if the device is operated beyond the recommended

operating conditions.

Electrical Specifications continued