LEDFIRE ADV

Advanced Emergency Luminaire

Non-maintained operation

Soft-start charger to reduce building load

Lowest energy consumption (avg. <0.25W)

Fast emergency switch-over (<0.5s) for high-task areas

Long life electronics

8 years design life at max. ambient

High Quality Lithium battery (LiFePO4) and smart charger

Standalone (SPU)

Self test (AS2293/ IEC62034)

DALI (IEC62386)

Ektor wired monitored system

ORDERING INFORMATION

Order code

01693

Description

Ledfire Advanced Emergency

Luminaire DALI - D63 - W/F&P

Driver Type

DALI DT1 Emergency

Item Code

EV-LEDFIRE-ADV-DA

MECHANICAL

Body Material

Polycarbonate

Fitting Colour

White

Installation Type

Recessed

IP Rating

IP44 Front Face Only

ELECTRICAL

Electrical Rating

Class II

Input Frequency

50 Hz

Input voltage

230Vac

In Australia the Input voltage is defined as 230Vac -6%/+10%. This effectively

means that the voltage range of these products are 216Vac - 253Vac or 240V

+6%

Maximum Wattage

2.5 W

Standby Power

0.25 W

Standby power for non-maintained/switched maintained emergency devices is

measured when the light is off and the charger is in standby mode. For

maintained emergency devices, standby power is measured when the light is on

and the charger is in standby mode. Typically, charging occurs for the first 16

hours after the device is powered or after a battery discharge.

Working Temp Range

0 to 40 °C

DRIVER

Dimmable

No

Driver Included

Yes

Driver Type

DALI DT1 Emergency

Flex & Plug or Lead Length

1200 mm

Wiring Type

Re-wireable Flex & Plug (2 pin)

EMERGENCY (EM SUFFIX)

Replacement Battery Code

01302

Emergency Classification

C0:D63, C90:D63

Emergency Control

DALI Monitored (DT1)

DALI Monitored ~ Supports Emergency test and monitoring over DALI

(IEC62386) with full compliance to IEC62386-202.

Emergency Duration

90 mins

Emergency Lumen Output

330 lm

Emergency Mode

Non-Maintained

Emergency Output Power

2100 mW

COMPLIANCE

Product Design Life

8 years

The product design life relates to the total product life which includes LEDs,

drivers and the enclosure. This is different to the LED lifetime which only refers

to the economical lifetime of the LEDs at which time the lumen output has

dropped below the L Value. The product design life is calculated at the

maximum ambient or working temperature of the product and takes into

account the Daily Use.

Standards

AS/NZS 60598.1

AS 60598.2.22

AS/NZS 61347.1

AS/NZS 61347.2.13

AS CISPR 15

AS/NZS 2293.3

1300 438 658

sales@evolt.com.au

ektor.com.au

© 2025 Evolt