CG

Higher Capacitance, Low ESR, High ripple current.

Load life of 2000 hours at 105

°C.

SMD type : Lead free reflow soldering condition at 260

Adapted to the RoHS directive (2002/95/EC).

series

–55 to +105

°C

2.5 to 16V

47 to 3300

µF

± 20% at 120Hz, 20°C

Not more than value of Standard ratings

at 120Hz, 20

°C

Not more than value of Standard ratings

at 100kHz, 20

°C

Not more than value of Standard ratings.

After 2 minute's application of rated voltage.

20

°C

Z +105

°C / Z+20°C 1.25

(100kHz)

Z-55

°C / Z + 20°C 1.25

After 2000 hours' application of rated voltage

at 105

°C, capacitors meet the specified value

for life characteristics listed at right.

After 1000 hours' application of rated voltage

at 60

°C 90%RH, capacitors meet the specified

value for life characteristics listed at right.

To comply with recommended conditions for

reflow soldering. Pre-heating shall be done

at 150 to 200

°C and for 60 to 180 sec.

In the case of peak temp, less than 250

°C,

reflow soldering shall be within two times.

In the case of peak temp, less than 260

°C,

reflow soldering shall be once.

Measurement for solder temperature profile

shall be made at the capacitor top and the

terminal.

Navy blue print on the case top.

CONDUCTIVE POLYMER

ALUMINUM SOLID ELECTROLYTIC CAPACITORS

1 ESR measurements should be made at a point on the terminal nearest where the ternimals protrude through the plastic platform.

2 Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes at the temperature of 105

°C.

3 Initial value : The value before test of examination of resistance to soldering.

Item

Performance Characteristics

Category Temperature Range

Rated Voltage Range

Rated Capacitance Range

Capacitance Tolerance

tan

δ

ESR ( 1)

Leakage Current ( 2)

Characteristics of Temperature

Impedance Ratio

Endurance

Damp Heat

Resistance to

Soldering Heat

Marking

Capacitance change

tan

δ

ESR ( 1)

Leakage current ( 2)

Within

± 20% of initial value ( 3)

150% or less of the initial specified value

150% or less of the initial specified value

Initial specified value or less

Capacitance change

tan

δ

ESR ( 1)

Leakage current ( 2)

Within

± 20% of initial value ( 3)

150% or less of the initial specified value

150% or less of the initial specified value

Initial specified value or less

Capacitance change

tan

δ

ESR ( 1)

Leakage current ( 2)

Within

± 10% of initial value ( 3)

130% or less of the initial specified value

130% or less of the initial specified value

Initial specified value or less

Specifications

Chip Type, Higher Capacitance

CF

CG

Higher

Capacitance