AT9235 Assembly

Custom LED Assembly - Square Deep Extrusion.

Superior 24V design

Long operating lifetime

Square Deep Extrusion with front clip in Diffuser

Includes IP20 Rated 24V constant Voltage Driver

with Flex and Plug

Supplied with mounting Clips

2m Tails for easy wiring to remote driver

Custom extrusion Length ( Must be specified

before delivery)

Cut measurements are from end-to-end including

the endcaps

Cable entry is from the end of the extrusion unless

specified with the cut lengths.

Cut length does not always match LED Strip

cutting intervals. LED strip will be placed centre on

the Extrusion

ORDERING INFORMATION

Order code

20780

Description

Square Deep Assembly

14.4W/m IP20 LED Strip and

driver / RGB / 2M

Driver Power

60 W

Driver Type

Fixed output

Item Code

AT9235/2M/AT9253/RGB/IP2

0

MECHANICAL

Body Material

Aluminium

Diffuser Material

PMMA

Fitting Colour

Silver

Installation Type

Surface mount

IP Rating

IP20

ELECTRICAL

Electrical Rating

Class II

Input Frequency

50 Hz

Input voltage

180-240

Maximum Wattage

60 W

Power Factor

0.95

Switch Type

Inline

Watts Per Meter (W/m)

14.4

Working Temp Range

0 to 40 °C

LAMP

Macadam Steps (SDCM)

3-step MacAdam Ellipse

Beam Angle

120 °

CCT Configuration

RGB

Lamp/LED voltage

24 V

LED's per meter

60

Lumens /m

360 lm/m

LED LIFETIME

LED Lifetime

>48000 hrs

This is the Reported LED Lifetime in Hours based on TM-21.

Atom does not list the projected or calculated LED lifetime,

which is normally longer as TM-21 Addendum B explicitly

states "The Calculated and Projected Lp(Dk) are not to be

reported". This Lifetime refers to the life of a single LED

however the system life is longer since the probability and

binomial distribution of all LEDs in the system means that the

average led is performing above the specification and

compensates for the LEDs falling below.

Ambient Temp (°C)

25 °C

40 °C

L70B50

>48000 hrs

>48000 hrs

This rating defines the performance of the led within its

lifetime. L relates to lumen depreciation, where the

proceeding number gives the resultant lumen output at the

end of it reported lifetime. L70, would mean 30% lumen

depreciation which means 70% of its initial output and is

tested accordingly to TM-21. The B part refers to failures,

which can be define as the percentage of LEDs which fall

below the L value in the projected lifetime. A value of B10

refers to 10% failure and a value of B50 refers to 50% failure.

After the defined lifetime, the system will reach the defined

lumen depreciation and the average led failures is defined by

the B rating. The B rating is defined in and tested to IEC62717.

1300 438 658

sales@evolt.com.au

atomlighting.com.au

© 2025 Evolt