Optoway

TRSL-9115WG

***********************************************************************************************************************************************************************

***********************************************************************************************************************************************************************

Tel: 886-3-5979798

Fax: 886-3-5979737

E-mail: sales@optoway.com.tw

http: // www.optoway.com.tw

12/1/2005 V3.0

2

Transmitter Specifications (0

Parameter

Symbol

Min

Typ

Max

Units

Notes

Optical

Optical Transmit Power

Po

-5

---

0

dBm

1

Output Center Wavelength

λ

1280

1310

1335

nm

Output Spectrum Width

∆λ

---

---

1

nm

-20 dB Width

Side Mode Suppression Ratio

SMSR

30

dB

Extinction Ratio

8.2

---

---

dB

Output Eye

Compliant with Bellcore GR-253-GORE and ITU-T Recommendation G.957

Optical Rise Time

150

ps

20% to 80% Values

Optical Fall Time

150

ps

20% to 80% Values

Relative Intensity Noise

RIN

-120

dB/Hz

Electrical

Power Supply Current

Icc

180

mA

2

Data Input Current – Low

-350

µA

Data Input Current – High

350

µA

Differential Input Voltage

300

1600

mV

Data Input Voltage – Low

-2.0

-1.58

V

3

Data Input Voltage -- High

-1.1

-0.74

V

3

TX Disable Input Voltage – Low

0

0.5

V

TX Disable Input Voltage – High

2.0

Vcc

V

TX Disable Assert Time

10

µs

TX Disable Deassert Time

50

µs

Notes: 1. Output power is power coupled into a 9/125

µm single mode fiber.

2. Maximum current is specified at Vcc = Maximum @ maximum temperature.

3. These inputs are compatible with 10K, 10KH and 100K ECL and PECL inputs.

Receiver Specifications (0

Parameter

Symbol

Min

Typ

Max

Units

Notes

Optical

Sensitivity @ 2.488 Gbps

Sen1

---

-18

dBm

1

Sensitivity @ 1.25 Gbps

Sen2

-20

dBm

2

Maximum Input Power

Pin

0

---

dBm

Signal Detect -- Asserted

Pa

---

---

-18

dBm

Transition: low to high

Signal Detect -- Deasserted

Pd

-35

---

---

dBm

Transition: high to low

Signal Detect -- Hysteresis

1.0

---

4.0

dB

Wavelength of Operation

1100

---

1600

nm

Electrical

Power Supply Current

Icc

110

140

mA

Data Output Voltage – Low

-2.0

-1.58

V

3

Data Output Voltage – High

-1.1

-0.74

V

3

Signal Detect Output Voltage -- Low

0

0.8

V

Signal Detect Output Voltage -- High

2.0

Vcc+0.3

V

Notes: 1. Minimum sensitivity and saturation levels at BER=1E-10 for a 2

2. Minimum sensitivity and saturation levels at BER=1E-12 for a 2

3. These outputs are compatible with 10K, 10KH and 100K ECL and PECL inputs.