SSD Series – Riedon™ Digital Current Sensor with RS485/MODBUS Interface by Bourns

Optional SSD Connector Sets

Optional SSD Serial Connection Kit

SSD-CONN-SET

SSD-SERKIT

Standard Connector Set

Includes

Molex P/N

Description

1 pc.

1053071204

4-Pin Female

1 pc.

1053071202

2-Pin Female

6 pcs.

1053002200

20-22 AWG Female Crimp Terminals

1 pc.

1053251004

4-Pin TPA

1 pc.

1053251002

2-Pin TPA

Serial Connection Kit

Includes

Description

1 pc.

SSD to DB-9F Serial Adapter

1 pc.

5 VDC USB Power Cable

1 pc.

4-Pin Programming Cable (1 m Length)

The SSD serial connection kit simplifies the initial setup of the

SSD Series Digital Current Sensor. It includes the necessary

components to connect USB to CAN and USB to RS-485 serial

adapters that have a 9-pin DB-9 male output connector. It

includes jumpers to switch from RS-485 to CANbus and enable

a termination resistor. USB to serial adapter not included.

USB to RS-485 Adapter - From DTEK, StarTech and others with

RS-485 on DB9 pins 1 and 2 and the ground on pin 5. Note:

Some adapters have the 485A and 485B pins reversed.

USB to CANbus adapter - From PEAK, Kvaser and others with

CAN on DB9 pins 2 and 7 and the ground on pin 3.

Specifications are subject to change without notice.

Users should verify actual device performance in their specific applications.

The products described herein and this document are subject to specific legal disclaimers as set forth on the last page of this document, and at www.bourns.com/docs/legal/disclaimer.pdf.