STM32F429NET6TR datasheet(27/231 Pages) STMICROELECTRONICS

27 / 231 page

DocID024030 Rev 6

27/231

STM32F427xx STM32F429xx

Functional overview

The over-drive mode allows operating at a higher frequency than the normal mode

for a given voltage scaling.

–

In Stop modes

The MR can be configured in two ways during stop mode:

MR operates in normal mode (default mode of MR in stop mode)

MR operates in under-drive mode (reduced leakage mode).

•

LPR is used in the Stop modes:

The LP regulator mode is configured by software when entering Stop mode.

Like the MR mode, the LPR can be configured in two ways during stop mode:

–

LPR operates in normal mode (default mode when LPR is ON)

–

LPR operates in under-drive mode (reduced leakage mode).

•

Power-down is used in Standby mode.

The Power-down mode is activated only when entering in Standby mode. The regulator

output is in high impedance and the kernel circuitry is powered down, inducing zero

consumption. The contents of the registers and SRAM are lost.

Refer to Table 3 for a summary of voltage regulator modes versus device operating modes.

Two external ceramic capacitors should be connected on VCAP_1 and VCAP_2 pin. Refer to

Figure 22: Power supply scheme and Table 19: VCAP1/VCAP2 operating conditions.

All packages have the regulator ON feature.

3.18.2

Regulator OFF

This feature is available only on packages featuring the BYPASS_REG pin. The regulator is

disabled by holding BYPASS_REG high. The regulator OFF mode allows to supply

externally a V12 voltage source through VCAP_1 and VCAP_2 pins.

Since the internal voltage scaling is not managed internally, the external voltage value must

be aligned with the targeted maximum frequency. Refer to Table 17: General operating

conditions.The two 2.2 µF ceramic capacitors should be replaced by two 100 nF decoupling

capacitors. Refer to Figure 22: Power supply scheme.

When the regulator is OFF, there is no more internal monitoring on V12. An external power

supply supervisor should be used to monitor the V12 of the logic power domain. PA0 pin

should be used for this purpose, and act as power-on reset on V12 power domain.

Table 3. Voltage regulator configuration mode versus device operating mode(1)

1. ‘-’ means that the corresponding configuration is not available.

Voltage regulator

configuration

Run mode

Sleep mode

Stop mode

Standby mode

Normal mode

MR or LPR

Over-drive

mode(2)

2. The over-drive mode is not available when VDD = 1.7 to 2.1 V.

Under-drive mode

MR or LPR

Power-down

mode

Yes

STM32F429NET6TR 数据表(PDF) 27 Page - STMicroelectronics

STM32F429NET6TR 数据表(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载