STA2058

Features summary

3/20

1

Features summary

●

ARM7TDMI 16/32 bit RISC CPU based host microcontroller running at a frequency up

to 66 MHz.

●

Complete Embedded Memory System:

–

FLASH 256K bytes + 16K bytes (100K erasing/programming cycles)

–

RAM 64K bytes.

●

External memory interface provides glueless support for up to four banks of external

SRAM, FLASH, ROM.

●

High Performance GPS engine (HPGPS).

●

ST Proprietary CMOS (0.18 µm) Flash Embedded technology.

●

SBAS (WAAS and EGNOS) supported

●

-40°C to 85°C operating temperature range.

●

144-pin LFBGA package and 64-pin LQFP package

●

Power Supply:

–

3.0V to 3.6V operating supply range for Input/Output periphery

–

3.0V to 3.6V operating supply range for A/D Converter reference

–

1.8V operating supply range for core supply provided either by internal Voltage

Regulator (with external stabilization capacitor) or by external supply voltage.

●

Reset and Clock Control Unit able to provide low power modes (WAIT, SLOW, STOP,

STANDBY) and to generate the internal clock from the external reference through

integrated PLL.

●

48 programmable General Purpose I/O, each pin programmable independently as

digital input or digital output; 40 (30 in LQFP64) are multiplexed with peripheral

functions; 16 can generate an interrupt on input level/transition.

●

Real time clock module with 32khz low power oscillator and separate power supply to

continue running during stand-by mode.

●

16-bit Watchdog Timer with 8 bits prescaler for system reliability and integrity.

●

2 CAN modules compliant with the CAN specification V2.0 part B (active) and bit rate

can be programmed up to 1 MBaud.One additional CAN at 1Mbps (for STA2058 EM

SIP version)

●

Four 16-bit programmable Timers with 7 bit prescaler, up to two input capture/output

compare, one pulse counter function, one PWM channel with selectable frequency

each.

●

4 channels 12-bit sigma-delta Analog to Digital Converter, single channel or multi

channel conversion modes, single-shot or continuous conversion modes, sample rate 1

KHz, conversion range 0-2.5V.

●

Three Serial Communication Interfaces (UART) allow full duplex, asynchronous,

communications with external devices, independently programmable TX and RX baud

rates up to 625K baud.

●

One UART adapted to suit Smart Card interface needs, for asynchronous SC as

defined by ISO 7816-3. It includes SC clock generation.

●

Two Serial Peripheral Interfaces (SPI) allow full duplex, synchronous communications

with external devices, master or slave operation, max baud rate of 5.5Mb/s. One SPI

may be used as Multimedia Card interface.