2.125"

[53.98]

2.4"

[60.96]

Unprotected Pair 2

Unprotected Pair 1

Protected Pair 2

Protected Pair 1

Keying Pin

Even Terminals

Odd Terminals

Field Side

Electronics Side

9

7

5

3

1

10

8

6

4

2

1.0”

[25.40]

{

}

}

{

NOTE: DO NOT daisy chain grounds. NOT intended for shield termination.

Install ground in accordance with all applicable codes.

PCB1B-WKEY

Installation Instructions

Terminal Assignments

Feature

■ Accommodates 26 to 10 AWG Wires

Edco PCB1B-WKEY

Card Edge Terminal Connector

Edco’s PCB1B-WKEY base was designed to accommodate up to 10 AWG wire.

In addition, it offers flat/phillips terminal screws. The Edco PCB1B-WKEY can be

mounted using two #6 size screws.

The Edco PCB1B-WKEY is the standard socket for all of Emerson Network Power’s

plug-in style surge suppressor modules including the Edco PC642, PHC, SLCP,

PC2TEL, 5W8-30 and others.

General Technical Specifications

Dimensions (in / mm)

0.0775˝ H x 1.0˝ W x 2.4˝ L

[2 x 25.4 x 61 mm]

Emerson Network Power Contact information

Surge Protection

100 Emerson Parkway

Binghamton, NY 13905

T: (607) 721-8840

T: (800) 288-6169

F: (607) 722-8713

E: SurgeTech@Emerson.com

IO-50115 5/14 Rev. 2 Printed in USA

www.EmersonNetworkPower.com/Surge

While every precaution has been taken to ensure accuracy and completeness herein, Emerson Network Power Surge Protection assumes no responsibility, and disclaims all liability, for damages

resulting from use of this information or for any errors or omissions. Specifications are subject to change without notice.

Emerson Network Power, the Emerson Network Power logo and Edco are trademarks

and service marks of Emerson Electric Co. ©2014 Emerson Electric Co.

Seulement le personnel qualifié

doit installer ou maintenir ce

systéme. Des précautions de

sécurité en électricité doivent être

suivis lors de l’installation ou de la

maintenance de cet equipement.

Pour eviter tout risque de choc

électrique, débranchez et verouiller

toutes les sources d’alimentation

de cet equipement avant de.

Only qualified personnel should

install or service this system.

Electrical

safety

pre-cautions

must be followed when installing

or servicing this equipment. To

prevent risk of electrical shock,

turn off and lock out all power

sources to the unit before making

electrical connections or servicing.

V DANGER!