TLC2264AMFKB datasheet(47/75 Pages) TI

47 / 75 page

TLC226x, TLC226xA

Advanced LinCMOS

 RAIL-TO-RAIL

OPERATIONAL AMPLIFIERS

SLOS177D – FEBRUARY 1997 – REVISED MARCH 2001

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

APPLICATION INFORMATION

driving large capacitive loads

The TLC226x is designed to drive larger capacitive loads than most CMOS operational amplifiers. Figure 58

and Figure 59 illustrate its ability to drive loads greater than 400 pF while maintaining good gain and phase

margins (Rnull = 0).

A smaller series resistor (Rnull) at the output of the device (see Figure 62) improves the gain and phase margins

when driving large capacitive loads. Figure 58 and Figure 59 show the effects of adding series resistances of

Ω, 20 Ω, 50 Ω, and 100 Ω. The addition of this series resistor has two effects: the first is that it adds a zero

to the transfer function and the second is that it reduces the frequency of the pole associated with the output

load in the transfer function.

The zero introduced to the transfer function is equal to the series resistance times the load capacitance. To

calculate the improvement in phase margin, equation 1 can be used.

∆Θ

m1 + tan

–1

× π× UGBW × R

null ×

Where :

(1)

∆Θ

m1 + improvement in phase margin

UGBW

+ unity-gainbandwidthfrequency

null + output series resistance

L + load capacitance

The unity-gain bandwidth (UGBW) frequency decreases as the capacitive load increases (see Figure 60). To

use equation 1, UGBW must be approximated from Figure 60.

Using equation 1 alone overestimates the improvement in phase margin, as illustrated in Figure 61. The

overestimation is caused by the decrease in the frequency of the pole associated with the load, thus providing

additional phase shift and reducing the overall improvement in phase margin. The pole associated with the load

is reduced by the factor calculated in equation 2.

) gm × R

null

Where :

(2)

+ factor reducingfrequencyof pole

gm + small-signaloutput transconductance (typically 4.83 × 10

– 3 mhos)

null + output series resistance

For the TLC226x, the pole associated with the load is typically 7 MHz with 100-pF load capacitance. This value

varies inversely with CL: at CL = 10 pF, use 70 MHz, at CL = 1000 pF, use 700 kHz, and so on.

Reducing the pole associated with the load introduces phase shift, thereby reducing phase margin. This results

in an error in the increase in phase margin expected by considering the zero alone (equation 1). Equation 3

approximates the reduction in phase margin due to the movement of the pole associated with the load. The

result of this equation can be subtracted from the result of the equation in equation 1 to better approximate the

improvement in phase margin.

TLC2264AMFKB 数据表(PDF) 47 Page - Texas Instruments

TLC2264AMFKB 数据表(HTML) 47 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

数据表下载