2

Amphenol ®

Amphenol Socapex Promenade de l’Arve -B.P.29 - 74311 THYEZ – F

Tel. :+ 33 (0) 4 50 89 28 00 - Fax : + 33 (0) 4 50 96 29 75

www.usbfield.com

Main

Main Characteristics

Characteristics

Environmental Protection

• Sealing (when mated) : IP67 (Temporary immersion)

• Salt Spray :

48 h with Nickel plating

> 500 h with Olive Drab Cadmium

• Fire Retardant / Low Smoke : UL94 V0 and NF F 16 101 & 16 102

• Vibrations : 10 – 500 Hz, 10 g, 3 axes : no discontinuity > 1micro s

• Shocks : IK06 : weight of 250 g drop from 40 cm [15.75 in] onto

connectors (mated pair)

• Humidity : 21 days, 43°C, 98% humidity

• Temperature Range : - 55°C / +85°C

Data Transmission

• USB Specification 2.0

Data Rate : Up to 480 Mb/s for High Speed USB

Mechanical

• Tri Start Thread coupling mechanism (MIL-DTL-38999

series III type) with anti-decoupling device

• 2 mechanical Coding / Polarization possibilities by the user

(receptacle insert rotation)

• USBF TV plug retent° in the receptacle : 100 N in the axis

• Mating cycles : 500 to 1500

Can be used with most of the USB cordset Brands : No tools required

Assembly Instructions

1.

Only if you need a full sealing (IP67) : Install the white

sticker around the plug, covering the 4 little holes of the

overmolding

2.

Insert the black O Ring around the front face of the USB A

plug. This O Ring will ensure the connection sealing.

3.

Insert the USB cordset into the metallic backshell

4.

Insert laterally to the cable the retention spacer (this spacer

is soft, in order to adapt to different shapes of overmolding)

and slide the overmolding of the USB-A plug into this

retention spacer

5.

Insert laterally to the cable the the friction ring

6.

Choose the right coding (2 positions) and insert the USB-A

plug into the protective plug. Reference is main key.

7.

Screw the backshell on the plug body. A spanner can be

necessary to fully screw it, and the connection to the

receptacle can help.

Important Note : The connection sealing is not done by the black

retention spacer (which is sloted), but by the front face

ORing (see 2.)

12

3

4

5

6

7

Plug Assembly

Receptacle Assembly

7

Insert the USB module from the rear. Reference is main key.

Beware to have a coding compatible with the coding you used for

the plug : on front view, the white shapes in the USBs

must be on the same side.

To remove the USB module, insert

the removal tool USBF ODE from the

Front, and push back the module.