8.2.1.2 Input Considerations

Input signals must cross VIL(max) to be considered a logic LOW, and VIH(min) to be considered a logic HIGH. Do

not exceed the maximum input voltage range found in the Absolute Maximum Ratings.

Unused inputs must be terminated to either VCC or ground. The unused inputs can be directly terminated if the

input is completely unused, or they can be connected with a pull-up or pull-down resistor if the input will be used

sometimes, but not always. A pull-up resistor is used for a default state of HIGH, and a pull-down resistor is used

for a default state of LOW. The drive current of the controller, leakage current into the SN74LVC595A-Q1 (as

specified in the Electrical Characteristics), and the desired input transition rate limits the resistor size. A 10kΩ

resistor value is often used due to these factors.

The SN74LVC595A-Q1 has CMOS inputs and thus requires fast input transitions to operate correctly, as defined

in the Recommended Operating Conditions table. Slow input transitions can cause oscillations, additional power

consumption, and reduction in device reliability.

Refer to the Feature Description section for additional information regarding the inputs for this device.

8.2.1.3 Output Considerations

The positive supply voltage is used to produce the output HIGH voltage. Drawing current from the output will

decrease the output voltage as specified by the VOH specification in the Electrical Characteristics. The ground

voltage is used to produce the output LOW voltage. Sinking current into the output will increase the output

voltage as specified by the VOL specification in the Electrical Characteristics.

Push-pull outputs that could be in opposite states, even for a very short time period, should never be connected

directly together. This can cause excessive current and damage to the device.

Two channels within the same device with the same input signals can be connected in parallel for additional

output drive strength.

Unused outputs can be left floating. Do not connect outputs directly to VCC or ground.

Refer to the Feature Description section for additional information regarding the outputs for this device.

www.ti.com

SN74LVC595A-Q1

SCASE97 – MAY 2025

Copyright © 2025 Texas Instruments Incorporated

Submit Document Feedback

21

Product Folder Links: SN74LVC595A-Q1