TDA7293

Applications information

Doc ID 6744 Rev 8

11/21

4.2

High efficiency

Constraints of implementing high power solutions are the power dissipation and the size of

the power supply. These are both due to the low efficiency of conventional AB class

amplifier approaches.

The circuit below in Figure 8 is a high efficiency amplifier which can be adopted for both hi-fi

and car-radio applications. The TDA7293 is a monolithic MOS power amplifier which can be

operated with a 100-V supply (120 V with no signal applied) while delivering output currents

up to ±6.5 A. This allows the use of this device as a very high-power amplifier (up to 180 W

peak power with THD = 10% and RL = 4 Ω); the only drawback is the power dissipation,

hardly manageable in the above power range.

The typical junction-to-case thermal resistance of the TDA7293 is 1 °C/W (max = 1.5 °C/W).

In worst case conditions, to avoid the chip temperature exceeding 150 °C the thermal

resistance of the heatsink must be 0.038 °C/W (at a maximum ambient temperature of

50 °C).

As the above value is pratically unreachable, a high efficiency system is needed in those

cases where the continuous average output power is higher than 50 to 60 W.

The TDA7293 was designed to work also in a higher efficiency way. For this reason there

are four power supply pins: two intended for the signal part and two for the power part. T1

and T2 are two power transistors that only operate when the output power reaches a certain

threshold (for example, 20 W).

If the output power increases, these transistors are switched on during the portion of the

signal where more output voltage swing is needed, thus "bootstrapping" the power supply

pins (13 and 15). The current generators formed by T4, T7, zener diodes Z1, Z2 and

resistors R7, R8 define the minimum drop across the power MOS transistors of the

TDA7293. L1, L2, L3 and the snubbers C9, R1 and C10, R2 stabilize the loops formed by

the "bootstrap" circuits and the output stage of the TDA7293.

By considering again a maximum average output power (music signal) of 20 W, in case of

the high efficiency application, the thermal resistance value needed from the heatsink is

2.2 °C/W (with VS = ±50 V and RL = 8 Ω). All components (TDA7293 and power transistors

T1 and T2) can be placed on a 1.5 °C/W heatsink, with the power darlingtons electrically

insulated from the heatsink.

Since the total power dissipation is less than that of a usual class AB amplifier, additional

cost savings can be obtained while optimizing the power supply, even with a large heatsink.

4.3

Bridge application

Another application suggestion is the bridge configuration, where two TDA7293 are used.

In this application, the value of the load must not be lower than 8

Ω for dissipation and

current capability reasons.

A suitable field of application includes hi-fi/TV subwoofer realizations. The main advantages

offered by this solution are:

High power performance with limited supply voltage level.

Considerably higher output power even with high load values, such as 16

Ω.

With RL = 8 Ω and VS = ±25 V, the maximum output power obtainable is 150 W, whilst with

RL = 16 Ω and VS = ±40 V, the maximum Pout is 200 W.