INA210CIRSWR.B datasheet(23/50 Pages) TI2

23 / 50 page

Time (500 µs/div)

VOUT

VREF

C002

Figure 7-4. Bidirectional Application Output Response

8 Power Supply Recommendations

The input circuitry of the INA21x can accurately measure beyond the power-supply voltage, V+. For example,

the V+ power supply can be 5 V, whereas the load power-supply voltage can be as high as 26 V. However,

the output voltage range of the OUT pin is limited by the voltages on the power-supply pin. Note also that the

INA21x can withstand the full input signal range up to 26 V at the input pins, regardless of whether the device

has power applied or not.

9 Layout

9.1 Layout Guidelines

• Connect the input pins to the sensing resistor using a Kelvin or 4-wire connection. This connection technique

ensures that only the current-sensing resistor impedance is detected between the input pins. Poor routing of

the current-sensing resistor commonly results in additional resistance present between the input pins. Given

the very low ohmic value of the current resistor, any additional high-current carrying impedance can cause

significant measurement errors.

• Place the power-supply bypass capacitor as closely as possible to the supply and ground pins. The

recommended value of this bypass capacitor is 0.1 μF. Additional decoupling capacitance can be added

to compensate for noisy or high-impedance power supplies.

www.ti.com

INA210, INA211, INA212, INA213, INA214, INA215

SBOS437K – MAY 2008 – REVISED NOVEMBER 2023

Submit Document Feedback

Product Folder Links: INA210 INA211 INA212 INA213 INA214 INA215

INA210CIRSWR.B 数据表(PDF) 23 Page - Texas Instruments