STPM01FTR datasheet(40/60 Pages) STMICROELECTRONICS

40 / 60 page

Theory of operation

STPM01

40/60

Doc ID 10853 Rev 8

8.21.1

Remote reset

The timing diagram of the operation is shown on the Figure 24. The time step can be as

short as 30 ns.

The internal reset signal is named RRR. Unlike the POR, the RRR signal does not cause

the 30 ms retard restart of analog module and the 120 ms retard restart of digital module.

This signal doesn’t clear the mode signals.

8.22

Reading data records

Data records reading will take place most often when there will be an on-board

microcontroller in an application. Such microcontroller will be able to read all measurement

results and all system signals (configuration, calibration, status, mode). Again, the time step

can be as short as 30 ns. There are two phases of reading, called latching and shifting.

Latching is used to sample results into transmission latches. The transmission latches are

the flip-flops that hold the data in the SPI interface. This is done with the active pulse on

SYN when SCS is idle. The length of pulse on SYN must be longer than 2 periods of

measurement clock, i.e. more than 500 ns at 4 MHz.

The shifting starts when SCS become active. In the beginning of this phase another, but

much shorter pulse (30 ns) on SYN should be applied in order to ensure that an internal

transmission serial clock counter is reset to zero. An alternative way is to extend the pulse

on SYN into the second phase of reading. After that reset is done, a 32 serial clocks per

data record should be applied. Up to 8 data records can be read this way. This procedure

can be aborted at any time by deactivation of SCS (see Figure 24).

The first read out byte of data record is least significant byte (LSB) of data value and of

course, the fourth byte is most significant byte (MSB) of data value. Each byte can be further

divided into a pair of 4-bit nibbles, most and least significant nibble (MSN, LSN). This

Figure 24.

Timing for providing remote reset request (1)

All the time intervals must be longer than 30 ns. t7 → t8 is the reset time, this interval must be longer than 30 ns as well.

SCS

SYN

SCLNLC

SDATD

SCS

SYN

SCLNLC

SDATD

STPM01FTR 数据表(PDF) 40 Page - STMicroelectronics

STPM01FTR 数据表(HTML) 40 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

数据表下载