STPM11 datasheet(19/46 Pages) STMICROELECTRONICS

19 / 46 page

STPM11, STPM12, STPM13, STPM14

Theory of operation

Doc ID 13167 Rev 8

19/46

For example, if R1 = 783k

Ω and R2 = 475Ω are used as resistor divider when the line

voltage is present, the positive voltage present at the input of the voltage channel of

STPM1x is:

Equation 3

since the maximum voltage value applicable to the voltage channel input of STPM1x is

+0.3V, the equivalent maximum line voltage applicable is:

Equation 4

VPK = R1+R2/R2 • 0.3 = 494.82

considering the case of NOM=2, the correspondent RMS values used for energy

computation is:

Equation 5

VRMS = VPK • 0.4219 = 208.76 [V]

Usually the supply voltage for the electronic meter is taken from the line voltage. In SWM,

since the line voltage is no longer present, another power source must be used in order to

provide the necessary supply to STPM1x and the other electronic components of the meter.

7.6

Power supply

The main STPM1X supply pin is the VCC pin. From the VCC pin two linear regulators provide

the necessary voltage for the analog part VDDA (3 V) and for the digital part VDDD (1.5 V).

The VSS pin represents the reference point for all the internal signals. The 100nF capacitor

should be connected between VCC and VSS, VDDA and VSS, VDDD and VSS. All these

capacitors must be located very close to the device.

The STPM1X contains a power-on-reset (POR) detection circuit. If the VCC supply is less

than 2.5 V, then the STPM1X goes into an inactive state, all the functions are blocked

asserting and a reset condition is set. This is useful to ensure that the correct device

operation at power-up and during power-down. The power supply monitor has built-in

hysteresis and filtering, which give a high degree of immunity to false triggering due to noisy

supply voltages.

A bandgap voltage reference (VBG) of 1.23 V ±1% is used as reference voltage level source

for the two linear regulators and for the A/D converters. Also, this module produces several

Table 11.

Nominal voltage values

NOM

KNOM

00.3594

10.3906

20.4219

30.4531

RMS

⋅

Obsolete

Product(s)

- Obsolete

Product(s)

STPM11 数据表(PDF) 19 Page - STMicroelectronics

STPM11 数据表(HTML) 19 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

数据表下载