M41T93 datasheet(27/56 Pages) STMICROELECTRONICS

27 / 56 page

DocID12615 Rev 8

27/56

M41T93

Clock operation

The on-chip capacitance can be calculated as follows:

CLOAD = 12.5 + [ACS:(AC6:AC0 value, decimal)] ● 0.125 pF

where ACS is the sign.

Examples:

ACAL (addr 12h) = 0

➔ CLOAD = 12.5 pF

ACAL = 10111100b

➔ CLOAD = 5 pF

ACAL = 00010100b

➔ CLOAD = 15 pF

With the analog calibration adjusted to its lowest value, the oscillator will see a minimum of

3.5 pF load capacitance as shown on the bottom row of Table 5.

Note:

These are typical values, and the total load capacitance seen by the crystal will include

approximately 1-2 pF of package and board capacitance in addition to the analog calibration

Any invalid value of analog calibration will result in the default capacitance of 25 pF (for CXI

and CXO).

Combining the digital adjustment range (–63 to +126 ppm) and analog adjustment range

(–15 to +95 ppm), the approximate overall adjustment range of the M41T93’s timekeeping is

–78 to +221 ppm.

Figure 12 represents a typical curve of clock ppm adjustment versus the analog calibration

value. Actual crystals may vary, so users should evaluate the crystals to be used with an

M41T93 device before establishing the adjustment values for a given application.

M41T93 数据表(PDF) 27 Page - STMicroelectronics