Features

•

Equipped with Arduino UNO R3 connectors and compatible with STEVAL-

IOD003V1, X-NUCLEO-IKS01A2 and NUCLEO-L073RZ boards.

•

The STEVAL-IOD003V1 features:

–

IO-Link (PHY) device layer based on L6362A

–

Operating voltage range 6.5 to 35 V

–

Dedicated CQ overload pin (wake-up)

–

Diagnostics pin (UVLO, overtemperature and cut-off)

–

UART interface

–

Linear regulators for independent supply from +24 V bus (12 mA 3.3 V and

100 mA 12 V)

–

LEDs for status and diagnostics

–

Overload and overheating protections with non-dissipative cut-off function

–

Full reverse polarity on IO-Link interface pins

–

EMC protections according to IO-Link v1.1 and IEC 60947-5-2

–

Ground and VCC wire break protections

•

The X-NUCLEO-IKS01A2 features:

–

LSM6DSL 3D accelerometer and 3D gyroscope

–

LSM303AGR 3D accelerometer and 3D magnetometer

–

LPS22HB pressure sensor

–

HTS221 capacitive digital relative humidity and temperature

–

DIL24 socket for additional MEMS adapters and other sensors

–

Free comprehensive development firmware library and samples for all

sensors compatible with STM32Cube firmware

•

The NUCLEO-L073RZ features:

–

STM32L073RZT6 32-bit microcontroller based on ARM® Cortex®-M0+ core

–

Pre-programmed IO-Link device stack (v1.1 compatible)

–

Arduino UNO R3 connectivity and ST morpho extension pin headers

–

Mbed-enabled (http://mbed.org)

–

On-board ST-LINK/V2-1 debugger/programmer with SWD connector

Description

The P-NUCLEO-IOD01A1 is an STM32 Nucleo pack composed of the NUCLEO-

L073RZ development board, the STEVAL-IOD003V1 evaluation board and the X-

NUCLEO-IKS01A2 expansion board.

The STEVAL-IOD003V1 offers an IO-Link device PHY layer (L6362A) while the

NUCLEO-L073RZ runs an IO-Link demo stack (developed by and property of

TEConcept Gmbh) compatible with rev 1.1 and firmware controlling the X-NUCLEO-

IKS01A2 sensors.

The STM32 Nucleo pack provides an affordable and easy-to-use solution for the

development of IO-Link and SIO applications, L6362A communication features and

robustness, together with the STM32L073RZT6 computation performance.

Product summary

STM32 Nucleo

pack for IO-Link

(PHY) device

fully compatible

with IO-Link v1.1

(PHY and stack)

P-NUCLEO-IOD01A1

IO-Link device

evaluation board

based on L6362A

with Arduino

connectors for

STM32 Nucleo

STEVAL-IOD003V1

IO-Link

communication

transceiver

device IC

L6362A

Motion MEMS

and

environmental

sensor expansion

board for STM32

Nucleo

X-NUCLEO-IKS01A2

STM32 Nucleo pack for IO-Link device fully compatible with IO-Link v1.1 (PHY

and stack)

P-NUCLEO-IOD01A1

Data brief

DB3635 - Rev 3 - October 2018

For further information contact your local STMicroelectronics sales office.

www.st.com