LM393LVDR datasheet(28/71 Pages) TI2

28 / 71 page

• V+ = 5 V, V– = GND

• Cstray (not shown) from VA TO GND = 10 pF

Figure 7-11. Square-Wave Oscillator Output Waveform

7.2.3 Adjustable Pulse Width Generator

Figure 7-12 is a variation on the square wave oscillator that allows adjusting the pulse widths.

R4 and R5 provide separate charge and discharge paths for the capacitor C depending on the output state.

100 kŸ

100 pF

100 kŸ

VCC

100 kŸ

OUT

1 MŸ

100 kŸ

Figure 7-12. Adjustable Pulse Width Generator

The charge path is set through R5 and D2 when the output is high. Similarly, the discharge path for the capacitor

is set by R4 and D1 when the output is low.

The pulse width t1 is determined by the RC time constant of R5 and C. Thus, the time t2 between the pulses

can be changed by varying R4, and the pulse width can be altered by R5. The frequency of the output can be

changed by varying both R4 and R5. At low voltages, the effects of the diode forward drop (0.8 V, or 0.15 V for

Shottky) must be taken into account by altering output high and low voltages in the calculations. RPU should be

at least 10x less than the smallest value of R4 or R5.

TL331LV, TL391LV, LM393LV, LM339LV

SNOSDA4D – JUNE 2020 – REVISED NOVEMBER 2023

www.ti.com

Submit Document Feedback

Product Folder Links: TL331LV TL391LV LM393LV LM339LV

LM393LVDR 数据表(PDF) 28 Page - Texas Instruments