DS000022

Rev D

July ‘99

©1999 REG No 277 4001, ENGLAND.

Page 8

FM-TX2-XXX

FM-RX2-XXX

Type Approval in UK

The TX2-418 is type approved in the UK to MPT1340 for use in Telemetry, Telecommand and In-

Building alarm applications.

CONFORMANCE to MPT1340 REQUIRES THAT:

1. The transmitting antenna must be one of the 3 variants given in the data sheet. Antenna

structures which yield ERP gain are not permitted.

2. The module must be directly and permanently connected to the transmitting antenna without

the use of an external feeder. Increasing the RF power level by any means is not permitted.

3. The module must not be modified nor used outside it's specification limits.

4. The module may only be used to send digital or digitised data. Speech and/or music are not

permitted.

5. The equipment in which the module is used

must carry an inspection mark located on the

outside of the equipment and be clearly visible. The minimum dimensions of the inspection

mark shall be 10 x 15 mm and the letter and figure height must be no less than 2mm. The

wording shall read:

6. Products intended for UK commercial application must be notified to the

Radiocommunications Agency (RA) on form RA 249 ( Cat I), obtainable from the RA's library

service, Tel 0171 211 0502 / 0505

OEM Manufacturers incorporating the TX2 as a component part of their product are authorised

by Radiometrix Ltd to quote their type-approval provided all the above conditions are complied

with.

European type approval

The TX2-433 & RX2-433 are type approved to ETS 300-220 for European use.

CONFORMANCE to ETS 300-220 REQUIRES THAT:

1. The transmitting antenna must be one of the 3 variants given in the data sheet. Antenna

structures which yield ERP gain are not permitted.

2. The module must be directly and permanently connected to the transmitting antenna without

the use of an external feeder. Increasing the RF power level by any means is not permitted.

3. The module must not be modified nor used outside it's specification limits.

4. The equipment in which the module is used

must carry an inspection mark located on the

outside of the equipment and be clearly visible. The minimum dimensions of the inspection

mark shall be 10 x 15 mm and the letter and figure height must be no less than 2mm. The

wording shall read:

OEM Manufacturers incorporating the TX2 & RX2 as a component part of their product are

authorised by Radiometrix Ltd to quote our type-approval provided all the above conditions are

complied with.

Most EEC member countries require notification before your product may be sold. We advise

you to contact the relevant country.

R

S

B

R

T

C

R

R

C