HCS512 datasheet(8/26 Pages) MICROCHIP

8 / 26 page

HCS512

DS40151D-page 8

4.4

Synchronization with Decoder

(Evaluating the Counter)

The KEELOQ technology patent scope includes a

sophisticated synchronization technique that does not

require the calculation and storage of future codes. The

technique securely blocks invalid transmissions while

providing transparent resynchronization to transmitters

inadvertently activated away from the receiver.

Figure 4-3 shows a 3-partition, rotating synchronization

window. The size of each window is optional but the

technique is fundamental. Each time a transmission is

authenticated, the intended function is executed and

the transmission’s synchronization counter value is

stored in EEPROM. From the currently stored counter

value there is an initial "Single Operation" forward win-

dow of 16 codes. If the difference between a received

synchronization counter and the last stored counter is

within 16, the intended function will be executed on the

single button press and the new synchronization

counter will be stored. Storing the new synchronization

counter value effectively rotates the entire synchroniza-

tion window.

A "Double Operation" (resynchronization) window fur-

ther exists from the Single Operation window up to 32K

codes forward of the currently stored counter value. It

is referred to as "Double Operation" because a trans-

mission with synchronization counter value in this win-

dow will require an additional, sequential counter

transmission prior to executing the intended function.

Upon

receiving

the

sequential

transmission

the

decoder executes the intended function and stores the

synchronization counter value. This resynchronization

occurs transparently to the user as it is human nature

to press the button a second time if the first was unsuc-

cessful.

The third window is a "Blocked Window" ranging from

the double operation window to the currently stored

synchronization counter value. Any transmission with

synchronization counter value within this window will

be ignored. This window excludes previously used,

perhaps code-grabbed transmissions from accessing

the system.

FIGURE 4-3:

SYNCHRONIZATION WINDOW

4.5

SLEEP Mode

The SLEEP mode of the HCS512 is used to reduce

current consumption when no RF input signal is

present. SLEEP mode will only be effective in systems

where the RF receiver is relatively quiet when no signal

is present. During SLEEP, the clock stops, thereby sig-

nificantly reducing the operating current. SLEEP mode

is enabled by the SLEEP bit in the configuration byte.

The HCS512 will enter SLEEP mode when:

• The RF line is low

• After a function output is switched off

• Learn mode is terminated (time-out reached)

The device will not enter SLEEP mode when:

• A function output is active

• Learn sequence active

• Device is in Programming mode

The device will wake-up from SLEEP when:

• The SLEEP input pin changes state

• The CLOCK line changes state

Note:

The synchronization method described in

this section is only a typical implementation

and because it is usually implemented in

firmware, it can be altered to fit the needs

of a particular system.

Blocked

Entire Window

rotates to eliminate

use of previously

used codes

Single Operation

Window

(32K Codes)

(16 Codes)

Double Operation

(resynchronization)

Window

(32K Codes)

Stored

Synchronization

Counter Value

Note:

During SLEEP mode the CLK line will

change from an output line to an input line

that can be used to wake-up the device.

Connect CLK to LRNIN via a 100K resistor

to reliably enter the Learn mode whenever

SLEEP mode is active.

HCS512 数据表(PDF) 8 Page - Microchip Technology

HCS512 数据表(HTML) 8 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

数据表下载