K

CMY

CY

MY

CM

Y

M

C

30.eps 175 lpi

45˚

black

Condensation has formed: Wait I to 2 hours for it to evaporate.

The unit cannot play discs other than the ones listed in these operating instructions.

The unit can only play the DVD-Vidieo if their region number is 3 , 5

ALL , or multiple region

number containing.

The disc may be dirty and may require cleaning.

Ensure that the disc is installed with the label of the side to be played facing upwards.

While stopped,and selecting DVD/CD as the signal source , Press [

] on the main unit and

[

10] on the remote control for 3 second until the Initialized words disappear from the TV

screen.Turn the unit off and on again. All settings will return to the default values.

Troubleshooting guide

Power

No power.

The unit is automatically

switched to the standby mode.

Insert the AC power supply cord securely and 25PIN connection wire into the household AC

outlet.

The SLEEP timer functioned.

Operation

No response when buttons

pressed

No operations can be

performed with the remote

control.

Play does not start (or stops

immediately) when you press

[

] (PLAY) .

Cannot select alternative

language.

No menu display.

No subtitles.

Incorrect subtitle position

Use the Subtitle Position in GUI display to change the subtitle position.

Soundtrack and/or subtitle

language is not the one

selected with the SETUP menus.

Cannot change angle.

You have forgotten your

password. Reset all settings to

Factory .

Check that the batteries are installed correctly.

The batteries are depleted: Replace them with new ones.

Point the remote control at the remote control sensor and operate.

The disc containing only one language has no other language selection.

If there is alternative language, try to select it via the disc menu.

There is menu display only for the disc recorded with menu.

The function depends on software availability.

Folder with more than 8 directories will be displayed as the folder with 8 directories.

Random and programmed plays cannot be seclected for some DVD-Video.

When the playlist or the time of play are not displayed on the screen, the adding of mark cannot be

done.

This function depends on software availability. Even if a disc has a number of angles

recorded; these angles may be recorded for specific scenes only.

Select DVD/CD for the signal source.

Cancel all group, programmed and random play.

Sound

No sound.

Distorted sound

Cannot access setup menu.

No mark function.

Folder with more than

8 directories in a digital CD

can not be displayed.

Random and programmed plays

cannot be selected.

Buzz can be heard during play.

There is AC power cord or fluorescent lamp near the Active Subwoofer. please put other

electrical appliances and connecting wires far away from the Active Subwoofer.

25

25

Check the connections.

Raise the volume.

Turn off mute.

Turn off the unit, find out and correct the cause, and then turn on the unit.

Causes as below:

- Positive and negative connecting cables of speakers are short circuited (naked

wires touching ).

- The speakers' rating impedance does not suit those of the unit.

- Speakers are overloaded because of high volume or power.

- The environment is hot, and of bad ventilation.

Only the disc with subtitles can display subtitles.

Subtitles are cleared from the television. Display the subtitles.

Some operations may be prohibited by the disc.

The unit may not be operating properly due to lightning, static electricity or some other

external factor.

Reset procedure:

Press [

] to switch the unit to the standby mode, and then back to ON.

Alternatively, Press [

] to switch the unit to standby mode, disconnect the AC power

supply cord and then reconnect it.

Before requesting service, make the following checks. Perform simple check of the parts or fine adjustment, and maybe the

problem will be solved and the unit can restore normal operation. If you are in doubt about some of the check points, or if the

remedies indicated in the table do not solve the problem, consult the dealer for instruction.

Black round digits indicate the page for reference, e.g.