M24C64-RBN3 datasheet(16/39 Pages) STMICROELECTRONICS

16 / 39 page

Device operation

M24128, M24C64, M24C32

16/39

4.6

Write operations

Following a Start condition the bus master sends a device select code with the Read/Write

bit (RW) reset to 0. The device acknowledges this, as shown in Figure 9, and waits for two

address bytes. The device responds to each address byte with an acknowledge bit, and

then waits for the data Byte.

Writing to the memory may be inhibited if Write Control (WC) is driven high. Any Write

instruction with Write Control (WC) driven high (during a period of time from the Start

condition until the end of the two address bytes) will not modify the memory contents, and

the accompanying data bytes are not acknowledged, as shown in Figure 8.

Each data byte in the memory has a 16-bit (two byte wide) address. The Most Significant

Byte (Table 4) is sent first, followed by the Least Significant Byte (Table 5). Bits b15 to b0

form the address of the byte in memory.

When the bus master generates a Stop condition immediately after the Ack bit (in the “10th

bit” time slot), either at the end of a Byte Write or a Page Write, the internal Write cycle is

triggered. A Stop condition at any other time slot does not trigger the internal Write cycle.

After the Stop condition, the delay tW, and the successful completion of a Write operation,

the device’s internal address counter is incremented automatically, to point to the next byte

address after the last one that was modified.

During the internal Write cycle, Serial Data (SDA) is disabled internally, and the device does

not respond to any requests.

4.7

Byte Write

After the device select code and the address bytes, the bus master sends one data byte. If

the addressed location is Write-protected, by Write Control (WC) being driven high, the

device replies with NoAck, and the location is not modified. If, instead, the addressed

location is not Write-protected, the device replies with Ack. The bus master terminates the

transfer by generating a Stop condition, as shown in Figure 9.

4.8

Page Write

The Page Write mode allows up to 32 bytes (for the M24C32 and M24C64) or 64 bytes (for

the M24128) to be written in a single Write cycle, provided that they are all located in the

same ‘row’ in the memory: that is, the most significant memory address bits (b13-b6 for

M24128, b12-b5 for M24C64, and b11-b5 for M24C32) are the same. If more bytes are sent

than will fit up to the end of the row, a condition known as ‘roll-over’ occurs. This should be

avoided, as data starts to become overwritten in an implementation dependent way.

The bus master sends from 1 to 32 bytes of data (for the M24C32 and M24C64) or 64 bytes

of data (for the M24128), each of which is acknowledged by the device if Write Control (WC)

is low. If Write Control (WC) is high, the contents of the addressed memory location are not

modified, and each data byte is followed by a NoAck. After each byte is transferred, the

internal byte address counter (inside the page) is incremented. The transfer is terminated by

the bus master generating a Stop condition.

M24C64-RBN3 数据表(PDF) 16 Page - STMicroelectronics

M24C64-RBN3 数据表(HTML) 16 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

数据表下载