Page <2>

V1.0

30/06/20

Copper Foil Tapes with

Conductive Adhesive

Newark.com/multicomp-pro

Farnell.com/multicomp-pro

Element14.com/multicomp-pro

Important Notice : This data sheet and its contents (the “Information”) belong to the members of the AVNET group of companies (the “Group”) or are licensed to it. No licence is granted for

the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change

without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness,

any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make

any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or

where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its

negligence. Multicomp Pro is the registered trademark of Premier Farnell Limited 2019.

Part Number Table

Description

Part Number

Copper Foil Tapes with Conductive Adhesive, Bright Copper, 3/4” × 18yd

MP700292

Copper Foil Tapes with Conductive Adhesive, Bright Copper, 1" × 18yd

MP700294

Copper Foil Tapes with Conductive Adhesive, Bright Copper, 2" × 18yd

MP700296

Copper Foil Tapes with Conductive Adhesive, Bright Copper, 3" × 18yd

MP700298

NOTE:

1. When applying pressure sensitive adhesive films to any surface, be sure that the surface is free from oil or other surface

contaminates such as powder, dust, or release agents. Adhesive performance should be carefully checked when used on

substrates containing plasticizers.

2. The above values are “Typical Values” which have a nominal range about them and are not intended for specification

purposes.