-0.5 V to +6.0 V

Input or Output Voltage

DC Forward Bias Current, Input or Output

-24mA source, +24mA sink

Storage Temperature Ceramic

-65 to 150 degrees Centigrade

Storage Temperature Plastic

-40 to 125 degrees Centigrade

Note 1. Referenced to Vss. Stresses above those listed under “absolute Maximum Ratings” may cause permanent damage to the device. This

is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operation sections of

this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect the device reliability.

Table 6. Absolute Maximum Ratings (note1)

3.3 V +/- 10% (3.0 V to 3.6 V)

3.3 V + 0.3V/-0.6V (2.7V to 3.6V)

Operating Ambient Temperature

Commercial (note 3)

Industrial (note 3)

Military (note 4)

0 to 70 degrees Centigrade

-40 to +85 degrees Centigrade

-55 to +125 degrees Centigrade

Note 1. Commercial, Industrial, and Military Conditions

Note 2. Low Voltage TTL Circuits are NOT functional to specifications below 3.0 Volts

These junction temperatures are compatible with the Commercial and Industrial Temperature Ranges.

Note 4. All circuits will be functional from -55 to +150 degrees centigrade junction temperature (military Ambient Temperature Range) but will

not necessary operate to published specifications. Only circuits specified as operational to extended temperature range may be used

when operating to Military temperature conditions.

Table 7. Recommended DC Operating Conditions

FVI (Five Volt Interface) Supply Voltage (notes 1,2)

5.0V +/- 10% (4.5 V to 5.5 V)

GTL (Gunning Transistor Logic) Supply Voltage (notes 1,3)

1.2V +/- 5% (1.14 V to 1.26 V)

CTT (Center Tap Terminated) Supply Voltage (notes 1,4)

1.5V +/- 10% (1.35 V to 1.65 V)

Note 1. Commercial, and Industrial Use Only -40 +85 degrees Centigrade

Note 2. I/O Circuits Only takes Special External Power Distribution and May NOT be mixed with GTL or CTL circuits on any one side of the die.

Only a very limited buffer set is available.

Note 3. I/O Circuits Only takes Special External Power Distribution and May NOT be mixed with FVI or CTL circuits on any one side of the die.

Only a very limited buffer set is available.

Note 4. I /O Circuits Only takes Special External Power Distribution and May NOT be mixed with FVI or GTL circuits on any one side of the die.

Only a very limited buffer set is available.

ISB35000 SERIES

13/15