17

Carlo Gavazzi Ltd.

RGC2, RGC3

RGC2, RGC3 DS ENG

05/10/20

Filter connection diagram

Filtering

Part number

Suggested filter for EN 55011 Class

A compliance

Maximum heater current [AAC]

RGC2A60..10

220 nF / 760 V / X1

10 AAC

RGC2A22..25

220 nF / 275 V / X1

25 AAC

RGC2A60..25

220 nF / 760 V / X1

25 AAC

RGC2A60..40

330 nF / 760 V / X1

40 AAC

RGC2A60..75

470 nF / 760 V / X1

65 AAC

RGC3A22..10

220 nF / 275 V / X1

10 AAC

RGC3A60..10

220 nF / 760 V / X1

10 AAC

RGC3A22..20

220 nF / 275 V / X1

25 AAC

RGC3A60..20

220 nF / 760 V / X1

25 AAC

RGC3A60..25

330 nF / 760 V / X1

25 AAC

RGC3A60..30

470 nF / 760 V / X1

30 AAC

RGC3A60..40

470 nF / 760 V / X1

40 AAC

RGC3A60..48

470 nF / 760 V / X1

48 AAC

RGC3A60..65

470 nF / 760 V / X1

65 AAC

Note:

• Control input lines must be installed together to maintain products’ susceptability to Radio Frequency interference.

• Use of AC solid state relays may, according to the application and the load current, cause conducted radio interferences. Use

of mains filters may be necessary for cases where the user must meet E.M.C requirements. The capacitor values given inside

the filtering specification tables should be taken only as indications, the filter attenuation will depend on the final application.

• This product has been designed for Class A equipment. Use of this product in domestic environments may cause radio

interference, in which case the user may be required to employ additional mitigation methods.

• Surge tests on RGC..A, RGC..A..A.. models were carried out with the signal line impedence network. In case the line impedance

is less than 40Ω, it is suggested that AC supply is provided through a secondary circuit where the short circuit limit between

conductors or between conductors and ground is 1500 VA or less.

* For conformance to EN/IEC 61000-6-4, an external capacitor class X1, 220 nF, 275 VAC is to be connected across the input

control lines A1-A2 for AC control versions.

** With external varistor 275 V (S05K275) Type 2 connected between terminals 22 - 21 or terminals 24 - 21.

• Performance Criteria 1 (PC1): No degradation of performance or loss of function is allowed when the product is operated as

intended.

• Performance Criteria 2 (PC2): During the test, degradation of performance or partial loss of function is allowed. However when

the test is complete the product should return operating as intended by itself.

• Performance Criteria 3 (PC3): Temporary loss of function is allowed, provided the function can be restored by manual operation

of the controls.