Rev 1.1, February 2, 2007

Page 3 of 13

SL23EP09

General Description

The SL23EP09 is a low skew, low jitter Zero Delay Buffer

with very low operating current.

The product includes an on-chip high performance PLL that

locks into the input reference clock and produces nine (9)

output clock drivers tracking the input reference clock for

systems requiring clock distribution.

in addition to CLKOUT that is used for internal PLL

feedback, there are two (2) banks with four (4) outputs in

each bank, bringing the number of total available output

clocks to nine (9).

Input and output Frequency Range

The input and output frequency range is the same. But, it

depends on VDD and drive levels as given in the below

Table 1.

VDD(V)

Drive

Min(MHz)

Max(MHz)

3.3

HIGH

10

220

3.3

STD

10

167

2.5

HIGH

10

200

2.5

STD

10

133

Table 1. Input/Output Frequency Range

If the input clock frequency is DC (GND to VDD), this is

detected by an input frequency detection circuitry and all

nine (9) clock outputs are forced to Hi-Z. The PLL is

shutdown to save power. In this shutdown state, the product

draws less than 12 A supply current.

SpreadThru

If a Spread Spectrum Clock (SSC) were to be used as an

input clock, the SL23EP09 is designed to pass the

modulated Spread Spectrum Clock (SSC) signal from its

reference input to the output clocks. The same spread

characteristics at the input are passed through the PLL and

drivers without any degradation in spread percent (%),

spread profile and modulation frequency

Select Input Control

The SL23EP09 provides two (2) input select control pins

called S1 and S2. This feature enables users to selects

various states of output clock banks-A and bank-B, output

source and PLL shutdown features as shown in the Table 2.

The S1 (Pin-9) and S2 (Pin-8) inputs include 250 k

weak

pull-up resistors to VDD.

PLL Bypass Mode

If the S2 and S1 pins are logic High(1) and Low(0)

respectively, the on-chip PLL is shutdown and bypassed,

and all the nine output clocks bank A, bank B and CLKOUT

clocks are driven directly from the reference input clock. In

this operation mode SL23EP09 works like a non-ZDB fanout

buffer.

High and Low-Drive Product Options

The SL23EP09 is offered with High-Drive “-1H” and

Standard-Drive “-1” options. These drive options enable the

users to control load levels, frequency range and EMI

control. Refer to the AC electrical tables for the details.

Skew and Zero Delay

All outputs should drive the similar load to achieve output-to-

output skew and input-to-output specifications given in the

AC electrical tables. However, Zero delay between input

and outputs can be adjusted by changing the loading of

CLKOUT relative to the banks A and B clocks since

CLKOUT is the feedback to the PLL.

Power Supply Range (VDD)

The SL23EP09 is designed to operate in a wide power

supply range from 2.3V (Min) to 3.6V (Max). An internal on-

chip voltage regulator is used to supply PLL constant power

supply of 1.8V, leading to a consistent and stable PLL

electrical performance in terms of skew, jitter and power

dissipation. Contact SLI for 1.8V power supply version ZDB

called SL23EPL09.