EV6532-F-00A

– 5V TO 60V, 3-PHASE BLDC MOTOR PRE-DRIVER EVAL BOARD

EV6532-F-00A Rev. 1.0

www.MonolithicPower.com

2

8/10/2020

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2020 MPS. All Rights Reserved.

QUICK START GUIDE

1. Attach the input voltage (5

V ≤ VIN ≤ 60V) to the VIN connector, and attach the input ground to the

GND connector.

2. To enable the chip, attach a 3.3V or 5V constant voltage to the VH connector, then switch SW1 to

position 1 (top side).

3. To set the OCP threshold, attach the over-current protection (OCP) reference voltage (0.1

V ≤ VOC_REF

≤ 2.4V) to the OC_REF connector.

4. Attach the Hall signals coming from the motor to the CN1 connector. Attach the Hall sensor power

supply to the Hall sensor connector.

5. Attach the driving control signals generated by the external controller to the CN1 connector.