LTC1064-3

7

10643fa

NC (Pins 1, 6, 8 and 13): The “no connection” pins should

be preferably grounded. These pins are not internally

connected.

VIN, VOUT (Pins 2, 9): The input Pin 2 is connected to an

18k resistor tied to the inverting input of an op amp. Pin 2

is protected against static discharge. The device’s output,

Pin 9, is the output of an op amp which can typically

source/sink 3mA/1mA. Although the internal op amps are

unity gain stable, driving long coax cables is not recom-

mended.

When testing the device for noise and distortion, the

output, Pin 9, should be buffered (Figure 1).

The op amp

power supply wire (or trace) should be connected

directly to the power source. To eliminate switching

transients from filter output, buffer filter output with a

third order lowpass (see Figure 5).

AGND (Pins 3, 5): For dual supply operation these pins

should be connected to a ground plane. For single supply

operation both pins should be tied to one half supply

(Figure 3).

V+, V– (Pins 4, 12): Should be bypassed with a 0.1µF

capacitor to an adequate analog ground. Low noise,

nonswitching power supplies are recommended.

To avoid

latchup when the power supplies exhibit high turn-on

transients, a 1N5817 Schottky diode should be added

from the V+ and V– pins to ground (Figure 1, 2 and 3).

RIN A, OUT C (Pins 7, 14): A very short connection between

Pin 7 and Pin 14 is recommended. This connection should

be preferably done under the IC package. In a breadboard,

use a one inch, or less, shielded coaxial cable: the shield

should be grounded. In a PC board, use a one inch trace or

less; surround the trace by a ground plane.

50/100 (Pin 10): Ratio Pin.The DC level at this pin deter-

mines the ratio of clock frequency to the –3dB frequency of

the filter. The ratio is 75:1 when Pin 10 is at V+, 120:1 when

Pin 10 is at GND and 150:1 when Pin 10 is at V–. This pin

should be bypassed with a 0.1µF capacitor to analog

ground when it’s connected to V– or V+ (Figure 1). See

Tables 2 through 8 for typical gain and delay responses for

the three ratios.

fCLK (Pin 11): For ±5V supplies the logic threshold level is

1.4V. For ±8V and 0V to 5V supplies the logic threshold

levels are 2.2V and 3V respectively. The logic threshold

levels vary ±100mV over the full military temperature

range. The recommended duty cycle of the input clock is

50% although for clock frequencies below 500kHz the

clock “on” time can be as low as 200ns. The maximum

clock frequency for ±5V supplies is 4MHz. For ±7V sup-

plies and above, the maximum clock frequency is 7MHz.

Do not allow the clock levels to exceed the power supplies.

For single supply operation ≥6V use level shifting at Pin 11

with T2L levels (see Figure 4).

(Pin Numbers Refer to the 14-Pin Package)

PI FU CTIO S