LD2985 SERIES

9/13

Figure 13 : Load Transient

Figure 14 : Load Transient

EXTERNAL CAPACITORS

Like any low-dropout regulator, the LD2985 requires external capacitors for regulator stability. This

capacitor must be selected to meet the requirements of minimum capacitance and equivalent series

resistance. We suggest to solder input and output capacitors as close as possible to the relative pins.

INPUT CAPACITOR

An input capacitor whose value is 1µF is required with the LD2985 (amount of capacitance can be

increased without limit). This capacitor must be located a distance of not more than 0.5" from the input pin

of the device and returned to a clean analog ground. Any good quality ceramic, tantalum or film capacitors

can be used for this capacitor.

OUTPUT CAPACITOR

The LD2985 is designed specifically to work with ceramic output capacitors. It may also be possible to use

Tantalum capacitors, but these are not as attractive for reasons of size and cost. By the way, the output

capacitor must meet both the requirement for minimum amount of capacitance and E.S.R. (equivalent

series resistance) value. Due to the different loop gain, the stability improves for higher output versions

and so the suggested minimum output capacitor value, if low E.S.R. ceramic type is used, is 1µF for

versions. However, if an output capacitor lower than the suggested one is used, it's possible to make

stable the regulator adding a resistor in series to the capacitor.

IMPORTANT:

The output capacitor must maintain its ESR in the stable region over the full operating temperature to

assure stability. Also, capacitor tolerance and variation with temperature must be considered to assure

the minimum amount of capacitance is provided at all times. This capacitor should be located not more

than 0.5" from the output pin of the device and returned to a clean analog ground.

INHIBIT INPUT OPERATION

The inhibit pin can be used to turn OFF the regulator when pulled low, so drastically reducing the current

keep the regulator output ON at all times. To assure proper operation, the signal source used to drive the

inhibit pin must be able to swing above and below the specified thresholds listed in the electrical