Assembly Information

Connection with soldering wires on unmounted module: Do not pretin the solderpads but pretin the wires and solder for max. 4 s at

300 °C. Allow solderpoints to completely cool down before the next soldering. Prevent shear- or peel forces.

Soldering of wires with the module mounted on a heatsink: Pretin solderpads and wires and solder for max 3 s at 350 °C. Allow

solderpoints to completely cool down before the next soldering. Prevent shear- or peel forces.

The smallest unit (56 mm- 4 LEDs) can be removed by cutting with scissors between the designated solder pads.

The mounting of the module is facilitated by means of the double-sided adhesive on the back-surface of the module. Care must be

taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt particle. The mounting substrate

must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the module is appropriately

positioned, press on the module with about 20N/cm² (refer to application techniques of 3M adhesive transfer tapes). Make sure the

module has got a holohedral contact to the mounting surface.

The minimum bending radius is 2 cm. The module may be bent over a smaller radius but only in regions of the circuit board

containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.

The thermal length expansion coefficient of the modul is 17*10^-6cm/cm/K. When installing in environments with large variations in

temperature (e.g. outdoor applications) and operating length of more than 2 m, the use of metallic mounting surfaces is necessary.

Otherwise it is advisable to use an additional thicker adhesive tape to absorb the stress of any mismatch in expansion coefficients.

Productgroup

Productname

EAN *

S-Unit *

Ordering Guide

LINEARlight Flex

LM11A-W3-865

4008321187208

8

LINEARlight Flex

LM11A-W1-865**

4050300873879

8

LINEARlight Flex

LM11A-W3-854

4008321187185

8

LINEARlight Flex

LM11A-W1-854**

4050300817217

8

LINEARlight Flex

LM11A-W3-847

4008321187161

8

LINEARlight Flex

LM11A-W1-847**

4050300817194

8

LINEARlight Flex

LM11A-A

4008321086952

8

LINEARlight Flex

LM11A-Y1

4050300946016

8

LINEARlight Flex

LM11A-T

4008321086990

8

LINEARlight Flex

LM11A-B

4008321086976

8

EAN: Ordering number per single module

S-Unit: Modules per shipping unit

*)

Note: Typical performance data are subject to change without any further notice, particularly as LED technology evolves.

Related and Further Information

New creativity in lighting design

LED Modules for illuminated signs

138 W002 GB

The new dimension of light

153 S006 GB

OPTOTRONIC® Technical Guide

130 T008 GB

OPTOTRONIC® Data Sheets

http://catalog.myosram.com

OSRAM LED systems

www.osram.com/led-systems

Datasheet CONNECTsystem LM-xx Flex

www.osram.com/led-systems-downloads

Sales and Technical Support

Sales and technical support is given by the

local OSRAM subsidiaries.

On our world wide homepage all OSRAM

subsidiaries are listed with complete

address and phone numbers.

OSRAM GmbH

Hellabrunner Strasse 1

D - 81536 München

Germany

www.osram.com

+49 (0)89 6213-0

Page 4 of 4

LM11A - 25.03.2008