13/32

M25P05

Table 6. Protection Modes

Note: 1. As defined by the values in the Block Protect (BP1, BP0) bits of the Status Register, as shown in Table 2.

The protection features of the device are summa-

rized in Table 6.

When the Status Register Write Disable (SRWD)

bit of the Status Register is 0 (its initial delivery

state), it is possible to write to the Status Register

provided that the Write Enable Latch (WEL) bit has

previously been set by a Write Enable (WREN) in-

struction, regardless of the whether Write Protect

(W) is driven High or Low.

When the Status Register Write Disable (SRWD)

bit of the Status Register is set to 1, two cases

need to be considered, depending on the state of

Write Protect (W):

– If Write Protect (W) is driven High, it is possible

to write to the Status Register provided that the

Write Enable Latch (WEL) bit has previously

been set by a Write Enable (WREN) instruction.

– If Write Protect (W) is driven Low, it is

sible to write to the Status Register

Write Enable Latch (WEL) bit has previously

been set by a Write Enable (WREN) instruction.

(Attempts to write to the Status Register are re-

jected, and are not accepted for execution). As

a consequence, all the data bytes in the memo-

ry area that are software protected (SPM) by the

Block Protect (BP1, BP0) bits of the Status Reg-

ister, are also hardware protected against data

modification.

Regardless of the order of the two events, the

Hardware Protected Mode (HPM) can be entered:

– by setting the Status Register Write Disable

(SRWD) bit after driving Write Protect (W) Low

– or by driving Write Protect (W) Low after setting

the Status Register Write Disable (SRWD) bit.

The only way to exit the Hardware Protected Mode

(HPM) once entered is to pull Write Protect (W)

High.

If Write Protect (W) is permanently tied High, the

Hardware Protected Mode (HPM) can never be

activated, and only the Software Protected Mode

(SPM), using the Block Protect (BP1, BP0) bits of

the Status Register, can be used.

W

Signal

SRWD

Bit

Mode

Write Protection of the

Status Register

Memory Content

10

Software

Protected

(SPM)

Status Register is

Writable (if the WREN

instruction has set the

WEL bit)

The values in the BP1

and BP0 bits can be

changed

Protected against Page

Program and Sector

Erase

Ready to accept Page

Program and Sector

Erase instructions

00

11

01

Hardware

Protected

(HPM)

Status Register is

Hardware write protected

The values in the BP1

and BP0 bits cannot be

changed

Protected against Page

Program and Sector

Erase

Ready to accept Page

Program and Sector

Erase instructions