DQ

Name

Logic Level

Definition

Note

7

Data

Polling

’1’

Erase Complete or erase

block in Erase Suspend

Indicates the P/E.C. status, check during

Program or Erase, and on completion

before checking bits DQ5 for Program or

Erase Success.

’0’

Erase On-going

DQ

Program Complete or data

of non erase block during

Erase Suspend

DQ

Program On-going

6

Toggle Bit

’-1-0-1-0-1-0-1-’

Erase or Program On-going

Successive reads output complementary

data on DQ6 while Programming or Erase

operations are on-going. DQ6 remains at

constant level when P/E.C. operations are

completed or Erase Suspend is

acknowledged.

DQ

Program Complete

’-1-1-1-1-1-1-1-’

Erase Complete or Erase

Suspend on currently

addressed block

5

Error Bit

’1’

Program or Erase Error

This bit is set to ’1’ in the case of

Programming or Erase failure.

’0’

Program or Erase On-going

4

Reserved

3

Erase

Time Bit

’1’

Erase Timeout Period Expired

P/E.C. Erase operation has started. Only

possible command entry is Erase

Suspend (ES).

’0’

Erase Timeout Period

On-going

An additional block to be erased in parallel

can be entered to the P/E.C.

2

Toggle Bit

’-1-0-1-0-1-0-1-’

Chip Erase, Erase or Erase

Suspend on the currently

addressed block.

Erase Error due to the

currently addressed block

(when DQ5 = ’1’).

Indicates the erase status and allows to

identify the erased block

1

Program on-going, Erase

on-going on another block or

Erase Complete

DQ

Erase Suspend read on

non Erase Suspend block

1

Reserved

0

Reserved

Notes: Logic level ’1’ is High, ’0’ is Low. -0-1-0-0-0-1-1-1-0- represent bit value in successive Read operations.

Table 9. Status Register Bits

that is after the fourth W pulse for programming or

after the sixth W pulse for erase. It must be per-

formed at the address being programmed or at an

address within the block being erased. If all the

blocks selected for erasure are protected, DQ7 will

be set to ’0’ for about 100

µs, and then return to the

previous addressed memory data value. See Fig-

ure 11 for the Data Polling flowchart and Figure 10

for the Data Polling waveforms. DQ7 will also flag

the Erase Suspend mode by switching from ’0’ to

’1’ at the start of the Erase Suspend. In order to

monitor DQ7 in the Erase Suspend mode an ad-

dress within a block being erased must be pro-

vided. For a Read Operation in Erase Suspend

mode, DQ7 will output ’1’ if the read is attempted

on a blockbeing erasedand the data value on other

blocks. During Program operation in Erase Sus-

pend Mode, DQ7 will have the same behaviour as

in the normal program execution outside of the

suspend mode.

11/34

M29W400T, M29W400B