P30L

www.vishay.com

Vishay Sfernice

Revision: 27-Jan-2025

4

Document Number: 51056

For technical questions, contact: sferpottrimmers@vishay.com

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

MECHANICAL SPECIFICATIONS

Mechanical travel

300° ± 5°

Operating torque / typical value

2 Ncm

2.83 oz.-inch

End stop torque

70 Ncm max.

99 oz.-inch max.

Tightening torque of mounting nut

250 Ncm max.

22.13 lb-inch max.

Unit weight

23 g to 32 g max.

0.8 oz. to 1.13 oz.

Terminals

e3: pure Sn

ENVIRONMENTAL SPECIFICATIONS

Temperature range

-55 °C to +125 °C

Climatic category

55/125/56

Sealing

Fully sealed - container IP67

OPTIONS

Special feature command shaft

Length is measured from the mounting surface to the free end of the shaft. The screwdriver

slot is aligned with the wiper within ± 10°. Special shafts are available, in accordance to

drawings supplied by customers. We recommend that customers should not machine tool

shafts, in order to avoid damage. Bending or torsion of terminals should also be avoided.

Panel sealing

The panel sealing device consists of a ring located in a groove on the potentiometer face.

Sealing is obtained by tightening the ring against the panel when mounting the

potentiometer.

Locating peg

Location is obtained by fitting a special washer on the mounting face of the potentiometer.

MARKING

• Vishay trademark

• Full ordering information (see Ordering Information table)

• Manufacturing date code

• Marking of terminals 3, and a, b, c

APPLICATION NOTE

The potentiometer shall be used in voltage divider with an impedance load at least

100 times higher than the total potentiometer nominal resistance value.

Advised load impedance:

1 M

Ω min. for resistance range of 1kΩ to 50 kΩ

(1) a

(2) b

c (3)

cw

V

s

V

e

Z >

1 M

Ω