TLV9032DDFR datasheet(30/85 Pages) TI2

30 / 85 page

Figure 7-11. Square-Wave Oscillator Output Waveform

7.2.3 Adjustable Pulse Width Generator

Figure 7-12 is a variation on the Square-Wave Oscillator that allows adjusting the pulse widths.

R4 and R5 provide separate charge and discharge paths for the capacitor C depending on the output state.

100 kŸ

100 pF

100 kŸ

VCC

100 kŸ

OUT

1 MŸ

100 kŸ

Figure 7-12. Adjustable Pulse Width Generator

The charge path is set through R5 and D2 when the output is high. Similarly, the discharge path for the capacitor

is set by R4 and D1 when the output is low.

The pulse width t1 is determined by the RC time constant of R5 and C. Thus, the time t2 between the pulses

can be changed by varying R4, and the pulse width can be altered by R5. The frequency of the output can be

changed by varying both R4 and R5. At low voltages, the effects of the diode forward drop (0.8V, or 0.15V for

Shottky) must be taken into account by altering output high and low voltages in the calculations.

7.2.4 Time Delay Generator

The circuit shown in Figure 7-13 provides output signals at a prescribed time interval from a time reference and

automatically resets the output low when the input returns to 0V. This is useful for sequencing a "power on"

signal to trigger a controlled start-up of power supplies.

TLV9020, TLV9021, TLV9022, TLV9024, TLV9030, TLV9031, TLV9032, TLV9034

SNOSDA3H – JUNE 2020 – REVISED NOVEMBER 2025

www.ti.com

Submit Document Feedback

Product Folder Links: TLV9020 TLV9021 TLV9022 TLV9024 TLV9030 TLV9031 TLV9032 TLV9034

TLV9032DDFR 数据表(PDF) 30 Page - Texas Instruments