24

22.0 Certification

FCC 2AJMTWIPY01R

IC

22263–WIPY01R

CE

0700

Copies of the certificates can be found on our website.

23.0 Regulator Information

23.1

EU Regulatory Conformance

Hereby, Pycom Ltd declares that this device is in compliance with the essential requirements and other relevant

provisions of Directive 1999/5/EC

23.2

Federal Communication Commission Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

23.2.1 RF Warning Statement

To comply with FCC RF exposure compliance requirements, the antennas used for this transmitter must be installed

to provide a separation distance of at least 20 cm from all persons and must not be co–located or operating in

conjunction with any other antenna or transmitter.

23.2.2 OEM integrator conditions

This device is intended only for OEM integrators under the following conditions:

1. The antenna must be installed such that 20 cm is maintained between the antenna and users, and

2. The transmitter module may not be co–located with any other transmitter or antenna.

As long as the two conditions above are met, further transmitter test will not be required. However, the OEM

integrator is still responsible for testing their end–product for any additional compliance requirements required with

this module installed.

To ensure compliance with all non–transmitter functions the host manufacturer is responsible for ensuring

compliance with the module(s) installed and fully operational. For example, if a host was previously authorized as

an unintentional radiator under the Declaration of Conformity procedure without a transmitter certified module

and a module is added, the host manufacturer is responsible for ensuring that the after the module is installed and

operational the host continues to be compliant with the Part 15B unintentional radiator requirements.

The module is limited to OEM installation ONLY. The module is limited to installation in mobile or fixed application.

We hereby acknowledge our responsibility to provide guidance to the host manufacturer in the event that they

require assistance for ensuring compliance with the Part 15 Subpart B requirements.