7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INITIAL BATTERY CHARGING

1. Charge your jump-start battery before using it for the first time.

2. Recharge the jump-start battery after every occasion of use if possible,

and thereafter, at least every 30 days.

3. Always avoid leaving your jump-start in a discharged state.

FOLLOW THE ABOVE POINTS TO ENSURE MAXIMUM LIFE FROM THE BATTERY.

Two means of charging the battery are provided:

1. Via a 230V mains electricity

supply, using the mains adaptor,

as shown.

2. Via a 12V supply using the vehicle

cigar lighter adapter with cable

and plug provided.

NOTE: Using a 12V vehicle supply,

the battery will not charge to

maximum, but only to

approx. 50% of its capacity.

NOTE: A 5 amp fuse is fitted into the cigarette lighter plug adaptor,

accessed by unscrewing the end cap of the adaptor. Take care

not to loose the spring when unscrewing this cap.

CHARGING USING THE 230V MAINS ADAPTOR

1. Plug the cable into the socket in

the charger, then plug the

adaptor into the mains supply

and switch on.

• The red CHARGING light on the

jump-start will come on to

indicate charging is in progress.

2. Continue to charge until the RED

charging light goes out. It is

important to note that this could

take several days, dependant

upon the state of charge of the

battery.

• Pressing the ‘TEST’ button, with

the charger disconnected, will

REVERSE