M58WR064EB datasheet(26/82 Pages) STMICROELECTRONICS

26 / 82 page

M58WR064ET, M58WR064EB

26/82

(no wrap). The Wrap Burst bit is used to select be-

tween wrap and no wrap. When the Wrap Burst bit

is set to ‘0’ the burst read wraps; when it is set to

‘1’ the burst read does not wrap.

Burst length Bits (CR2-CR0)

The Burst Length bits set the number of Words to

be output during a Synchronous Burst Read oper-

ation as result of a single address latch cycle.

They can be set for 4 words, 8 words or continu-

ous burst, where all the words are read sequential-

ly.

In continuous burst mode the burst sequence can

cross bank boundaries.

In continuous burst mode or in 4, 8 words no-wrap,

depending on the starting address, the device as-

serts the WAIT output to indicate that a delay is

necessary before the data is output.

If the starting address is aligned to a 4 word

boundary no wait states are needed and the WAIT

output is not asserted.

If the starting address is shifted by 1,2 or 3 posi-

tions from the four word boundary, WAIT will be

asserted for 1, 2 or 3 clock cycles when the burst

sequence crosses the first 64 word boundary, to

indicate that the device needs an internal delay to

read the successive words in the array. WAIT will

be asserted only once during a continuous burst

access. See also Table 10, Burst Type Definition.

CR14, CR5 and CR4 are reserved for future use.

M58WR064EB 数据表(PDF) 26 Page - STMicroelectronics