13

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

USING THE PARALLEL GUIDE FENCE

The parallel guide fence ensures that the planer travels parallel to the edge of

the wood, providing a straight cut at your desired cutting width. This feature is

helpful for planing door edges, wood trim and boards. To attach the parallel

guide fence:

1. Disconnect the planer from the power source.

2. Attach the parallel guide fence to

the left-hand side of the planer

using the lock knob.

3. Loosen the wing nut on the

parallel guide fence and slide the

fence to set the desired cutting

width indicated by the width

gauge. Retighten the wing nut.

NOTE: To ensure a square cut,

measure the front and back

of the fence and use a

square to make sure the

guide is set straight.

4. Rest the front shoe flat on the

workpiece surface and position

the fence firmly against the edge

of the workpiece Follow

instructions on page 11 to perform

your cut.