8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ADJUSTING THE BELT TRACKING

Having changed the belt, it is important

to make sure that the belt runs square on

the rollers. This is achieved by adjusting

the tracking.

To adjust the tracking, proceed as

follows:

1. Switch on the belt sander.

2. Adjust the tracking screw until the

sanding belt is running in line with the

flat side of the tool.

3. Turn the screw anti-clockwise to run

the belt into the tool. Turn the screw

clockwise to run the belt away from

the tool.

FITTING THE DUST COLLECTION BAG

When using the belt sander, certain materials will generate harmful or toxic dusts and

grit. For this reason it is important to fit the dust collection bag. Do not allow the

dustbag to get too full. Empty the bag before it becomes overloaded.

1. Put the plastic nozzle of the dust

collection bag over the dust

extraction outlet.

2. Push firmly home.

3. To empty the dust bag, grasp the bag

by the plastic nozzle and pull away

from the dust extraction outlet.

WARNING: ALWAYS WEAR EYE PROTECTION WHEN ADJSUTING OR

OPERATING THE SANDER.